SYNCO G1(A2) Wireless Lavalier Microphone System

Caring For Your SYNCO Product

Please keep the product in a dry, clean, dust-free environment. Keep corrosive chemicals, liquids and heat source away from the product to prevent mechanical damage. Use only a soft and dry cloth for cleaning the product. Malfunction may be caused by dropping or impact of external force. Do not attempt to disassemble the product, as doing so voids the warranty. Please have the product checked or repaired by authorized technicians if any malfunctions occur. Failure to follow all instructions may result in mechanical damage. Warranty does not apply to human errors.

Package List

• RX Receiver x1
• TX Transmitter x2
• Carrying Bag x1
• Furry Windshield x2
• 3-in-1 Charging Cable x1
• External Lav Mic (With Wind Muff) x2
• 3.5mm TRRS Phone Cable x1
• 3.5mm TRS Camera Cable x1

Product Instruction

TX Transmitter

• External Mic Input
• USB-C Port
• Power
• Reset (Help with Eject Pin)
• Low Cut
• Pairing
• Built-in Mic
• Pocket Clip
• Pairing Indicator
• Power Indicator

RX Receiver

• USB-C Port
• Power (Mono/Stereo Switch)
• Reset (Help with Eject Pin)
• Channel A Gain Control
• Channel B Gain Control
• 3.5mm Audio Output
• 3.5mm Monitoring Jack
• Pocket Clip
• Pairing Indicator
• Power Indicator

Indicator Status

Operations

1. Power Button: Long press the power button for 2 seconds to turn on/off the system. Short press the power button on the RX for Mono/Stereo switch.
2. Pairing: The system will pair automatically after power on. If you need manual pairing, long press the Channel A Gain Control and Channel B Gain Control on the RX, and the pairing button on the TX; the system will start to pair.
3. Connection: The receiver outputs audio signals to recording devices with a 3.5mm TRRS Phone Cable or a 3.5mm TRS Camera Cable. Please use the corresponding cable based on your device.
4. Installation: Attach the transmitter or the external mic to the speaker's clothing. Install the receiver to the camera's hot shoe via the pocket clip. (Note: When using the external mic, please insert it into the mic input properly.)
5. Gain Control: The initial value of the gain is the microphone's original volume. Each press of the gain control button increases the gain by one level, up to a maximum of four levels. When the gain is at its maximum level, pressing it once returns it to the initial value.
6. Charging: Please fully charge the TX and RX via the USB-C port and the charging cable before use.

Specifications

TX Transmitter

RX Receiver

Microphone

Warranty

Thank you for purchasing SYNCO products.

1. Customers are entitled to free replacement or repair service in case of quality defect(s) found in the product under normal use within 30 days upon receipt of the product.
2. Original SYNCO products are entitled to a 12-month limited warranty service. The warranty period begins on the date of purchase of brand new, unused products by the first end-user. Within the warranty period, if product defect or failure is attributable to material defection or technological problem, the defective product or defective part will be repaired or replaced without charge (service and materials fee).

Warranty Exclusions and Limitations

• Faults resulted from inappropriate use of a product without following its operation specification.
• Artificial damage, e.g. crash, squeeze, scratch, or soaking.
• Modifications to a product by its user or a third party without prior written consent of SYNCO, e.g. replacement of element or circuit, label alteration.
• The code on the product is inconsistent with that of the warranty certificate, or the code on the product or warranty certificate is altered or torn off.
• All consumable accessories attached to a product, like cable, wind muff, battery.
• Faults as a result of force majeure, such as fire, flood, lightning, etc.

Warranty Claim Procedure

If failure or any problem occurs to your product after purchase, please contact a local agent for assistance, or you can always contact SYNCO's customer service through email at support@syncoaudio.com. Please retain your sales receipt and warranty certificate as proof of purchase. If any of these documents are missing, only sales return or chargeable service will be provided. If the SYNCO product is out of the warranty coverage, the service and parts cost will be charged.

Warranty Certificate

Please register your warranty. Meanwhile, you are welcomed to contact us via Email: support@syncoaudio.com

USER INFORMATION

Customer Name:
Phone Number:
Email:
Address:

SALES INFORMATION

Sales Date:
Model:
Product Code:
Dealer:

REPAIR RECORD

Service Date:
Technician:
Issue:
RESULT: Solved / Unsolved / Returned (Replaced)