Danfoss MCAD B3 IP20 Industrial Drive

General Information

Dimensions and Clearances

Overall Dimensions:

• Height: 419 mm [16.5 inches]
• Width: 248 mm [9.8 inches]

Cooling Clearance: Minimum 200 mm [7.9 inches] required on all sides for adequate airflow.

Airflow: The unit is designed with air inlet at the bottom and air outlet at the top.

The drawing presents detailed views of the Danfoss MCAD B3 IP20 industrial drive. It includes a front view showing the control panel, side views illustrating overall dimensions (height 419mm, width 248mm), airflow direction (inlet at bottom, outlet at top), and required cooling clearance (minimum 200mm). An isometric view offers a 3D perspective. Details A and B show mounting hole specifications.

Mounting Details

The unit is designed for mounting on a base.

Mounting Base Dimensions:

• Length: 380 mm [15 inches] to 399 mm [15.7 inches] (overall depth)
• Width: 140 mm [5.5 inches] (mounting surface width)
• Detail A (Mounting Hole): Diameter 12 mm [0.47 inches], positioned 165 mm [6.5 inches] and 8 mm [0.32 inches] from edges.
• Detail B (Mounting Bracket Feature): Shows a slot with dimensions 11 mm [0.43 inches] and 6.8 mm [0.27 inches].

Notes and Disclaimers

Tolerance: Unless otherwise specified, the tolerance is ±1 mm [0.4 inch]. All dimensions are in millimeters [inch].

This drawing shows the most common version of this product variant. Small differences may occur depending on the final product configuration.

Center of Gravity: For reference only. The product configuration may influence the center of gravity in all three axes.

Grounding: A ground symbol [ground symbol] is indicated on the unit.

Drawing Information

Designed by: Danfoss

Date: 27-11-2015

Property: Property of Danfoss A/S Nordborg, Denmark. Two or three dimensional reproduction of contents to be authorized by Danfoss A/S.

Description: MCAD B3 IP20

Model: MCAD-B3-IP20