eSUN eVacuum Kit Pro 3 User Manual
Please read the user manual before using the eVacuum Kit.
The eSUN eVacuum Kit Pro 3 is a kit of vacuum storage bags designed for 3D printer filament. The kit includes a spool of eSUN ABS+ 3D Printer Filament, a white electric pump, a white plastic sealing clip, a bag of blue desiccant, and a clear vacuum storage bag with a valve.
Introduction
The 3D Printing Consumables Vacuum Kit preserves opened 3D printing materials that absorb moisture easily. It creates an airtight seal to prevent degradation of materials like PVA, ePA, ePA-CF, ePA-GF, ABSMAX and TPU-95A. This portable kit is for home use, pairs with the eBOX for optimal results, and is made of BPA-free, FDA-approved food-grade plastics, ensuring safety and eco-friendliness.
Accessories
- 10x Vacuum bags
- 2x Sealing clips
- 15x Desiccant bags (*allochroic silica gel)
- 1x Electric pump
Method of Use
- Place 3D filament and desiccant in the bag.
- Attempt to remove some air, then seal the vacuum bag using a sealing clip.
- Aim the electric pump at the air outlet, vacuum the air out of the bag, and then press the air outlet to form a seal.
- The contents are now vacuum packed.
Specifications
Electric Pump
Size: 10.4 x 4 x 4 cm
Weight: 113 g
Material of pump: ABS
Suction power: ≥ 4 L / minute
Vacuum Bags
Size: 33 x 38 cm
Thickness: 0.090 mm
Material: PA+PE, BPA free & FDA approved
Storage temperature: -20 to +85°C
Desiccant
Size: 45 x 45 mm
Weight: 3 g / bag
Material: Blue silica gel
Water absorption rate: 30%+
Attention:
- Keep out of reach of children.
- The desiccant must not be ingested.
- Avoid direct sunlight and moisture.
- Keep in a dry and cool environment.
- Please keep it sealed when not in use.
- Please replace with a new one when desiccant changes from blue to pink.
The desiccant is initially blue and turns pink when it has absorbed moisture.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| The vacuum bag cannot be vacuumed or the air leaks | Bag is not completely closed | Open the zipper of the bag and reseal the zipper with the sealing clip to ensure that the zipper is completely closed. |
| The air valve is not placed on a flat surface when pumping air | Re-position Bag so the Air Valve lies flat. | |
| The inlet of the electric pump is not in full contact with the air valve | Ensure the air suction tip is centered and placed flat on air valve. Apply moderate pressure. | |
| The electric pump is not working properly | Check if the wire is damaged and the connector is connected properly. | |
| Air Valve is not closed | Remove air from bag again. Immediately press center of air valve with finger to ensure seal. | |
| The bag is broken | Change a new one. |
Better nature, better life
