HKoenig Metal Floor Fan

Important Safety Instructions

• Use the fan only as described in this manual. Any other use is not recommended and may cause fire, injury, or electric shock.
• The appliance can be used by persons with reduced physical, sensory, or mental capabilities, or lack of experience or knowledge, provided they are supervised or instructed in safe use and understand the potential hazards.
• Children aged 8 and above can use the appliance if supervised and instructed in safe use, fully aware of the dangers.
• Cleaning and maintenance should not be carried out by children unless they are at least 8 years old and supervised by an adult.
• Keep the appliance and its power cord out of reach of children under 8 years of age.
• When using electrical equipment, always take safety precautions to prevent fire, electric shock, and/or injury from misuse.
• Ensure the voltage rating on the typeplate matches your installation's main voltage. If not, contact the dealer and do not connect the unit.
• Never leave the unit unattended while in operation.
• Keep this document handy and pass it to the future owner if you transfer the device.
• The device is not intended to be operated by an external timer or remote control system.
• Do not use the appliance if the cord or plug is damaged, it is not working properly, it has been damaged, or dropped. If the power cable is damaged, it must be replaced by the manufacturer, its agent, or a qualified person to avoid hazards.
• Children should be supervised to ensure they do not play with the device.
• Cleaning and maintenance must not be done by a child.
• Never remove the cover before unplugging the unit.
• The device must not be used if it has been dropped or shows visible signs of damage.
• Unplug the appliance when not in use.
• Do not use the fan near a gas or fire source, or in very humid, hot, or unstable environments.
• Never put your fingers into the protective grilles or touch the moving parts of the appliance.
• Do not use the unit with a speed control system.
• Young children, the elderly, or infirm individuals should not be exposed directly to the blower for extended periods.
• Ensure the fan is always on a flat, dry, and stable surface.
• NEVER COVER THE APPLIANCE, even temporarily, as it may overheat and create a fire hazard.
• The appliance is designed for domestic use only. It is not intended for use in the following situations, which are not covered by the warranty:
  • In staff kitchen areas in shops, offices, and other professional environments.
  • In farm hostels.
  • By guests in hotels, motels, and other residential environments.
  • In bed and breakfast type environments.

Product Description and Features

The sleek and modern high-velocity fan provides more powerful wind than ordinary plastic fans. It draws air from the floor and circulates it throughout the entire room, keeping it cool and breezy. Placing it near windows helps exhaust hot indoor stuffy air and pull in fresh outdoor air.

• Energy-saving, high-velocity motor for maximum air circulation.
• Tilt-adjustment for flexible use.
• Triple speed selection.
• Precision fan blades for powerful yet low-noise airflow.
• Chrome-stand, solid construction with thermal protection to prevent motor overheat.
• Versatile use: can be placed on the floor, desk, or mounted on the wall.

Parts Diagram

The fan assembly consists of the following parts:

• 1. Guard clips
• 2. Hook
• 3. Front protective grid
• 4. Blade
• 5. Rear protective grid
• 6. Fastening screw for protective grid
• 7. Washer for switch
• 8. Switch
• 9. Power cord
• 10. Motor
• 11. Flattened area on the motor shaft
• 12. Gasket for the base
• 13. Square bolt
• 14. Locknut
• 15. Tube base
• 16. Locknut
• 17. Front plastic gasket
• 18. Gasket for the base
• 19. Square bolt
• 20. Rear plastic gasket
• 21. Front plastic gasket

Operating Instructions

1. Ensure the voltage used corresponds with the indicated voltage.
2. Turn the speed control to the desired speed: 0 (off) and speeds 1, 2, 3 for Slow, Middle, Fast.
3. Tilt adjustment: By pushing the tilt-guard, you can adjust the fan to any preferred elevation.
4. Never touch the blades with your hand or any object.
5. Do not pull the cord too hard. If damaged after prolonged use, have it repaired by an electrical repairman.
6. To clean: Disconnect the power cord from the mains. Carefully remove the guard and blades. Do not drop the blades! First, use a soft cloth with mild soap to clean off oil stains. Then wipe and polish with a dry cloth. Never use polish or any corrosive liquid that could damage the paint, metal, or plastic. Reassemble the blades and securely lock the guard before use.
7. For wall mounting, ensure strong, durable tools are used. Make sure it is properly and firmly drilled into the wall to support the fan's weight.

No exchange will be made if the above instructions are not followed. Always test the product before purchasing.

Cleaning and Maintenance

• To clean: Unplug the power cord, carefully remove the guard and blades (do not drop them). Use a soft cloth with mild soap first to remove oil stains, then wipe and polish with a dry cloth. Never use polish or corrosive liquids that could damage paint, metal, or plastic. Reassemble the blades and close the guard before use.
• Do not use abrasive cleaning chemicals or detergents that could easily damage or deform your device.

Environment

CAUTION: Do not dispose of this product with household waste. Communities have selective collection systems for this type of product; inform your local authorities about where you can return it. Electrical and electronic products may contain hazardous substances harmful to the environment or human health and should be recycled. The symbol ? indicates that electrical and electronic equipment should be chosen carefully; it represents a wheeled waste container marked with a cross.

Contact Information

Adeva SAS / H.Koenig Europe - 8 rue Marc Seguin, 77290 Mitry-Mory, France

Website: www.hkoenig.com

Support: https://en.hkoenig.com

Telephone: +33 1 64 67 00 05