IKEA SPÄND Table Leg with Storage Assembly Instructions

Before You Begin

Ensure you have all parts and tools required. The assembly process requires a screwdriver. Avoid assembling on rough surfaces or carpets to prevent damage.

Important:

• Do not force parts together.
• If you encounter difficulties, refer to the troubleshooting section or contact IKEA.

Parts List

The following parts are included:

Assembly Steps

1. Step 1: Prepare the Legs

   Attach the adjustable feet to the bottom of the four main legs. Insert the screws into the designated holes on the legs and secure them with the provided Allen keys. Ensure the screws are tightened appropriately.

   Illustration shows four leg pieces being prepared with screws and adjustable feet. A close-up shows a screw being inserted and tightened with an Allen key.
2. Step 2: Attach the Shelves to the Legs

   Connect the two side shelf supports to the main legs using the provided screws (100013) and spacers (114584 / 100648). Insert the screws through the legs and into the shelf supports, using the spacers between the components. Tighten with the appropriate tool. Ensure the correct orientation as shown in the diagram.

   Illustration shows two sets of legs being connected by the shelf supports. A close-up shows the assembly of a leg, spacer, and shelf support with a screw.
3. Step 3: Attach the Second Shelf Support

   Repeat the process from Step 2 to attach the second shelf support to the other side of the legs, ensuring all connections are secure.

   Illustration shows the second shelf support being attached to the legs, mirroring the previous step.
4. Step 4: Secure the Base Structure

   Place the assembled leg structure onto a flat surface. Use the longer screws (10074054 / 10062305) and the Allen key (130445) to secure the base crossbars to the legs. Ensure the screws are inserted correctly and do not exceed the recommended depth (less than 25 mm or 7/8 inch).

   Illustration shows the leg structure being placed on a surface and secured with screws. A close-up highlights the correct screw length and insertion point.
5. Step 5: Attach the Top Surface Supports

   Attach the supports for the tabletop to the top of the legs using the remaining screws (10074054 / 10062305) and the Allen key (111531). Ensure these are securely fastened.

   Illustration shows the top of the legs and the attachment of the top surface supports. A close-up shows the screw and Allen key connection.
6. Step 6: Position and Attach the Shelves

   Slide the shelves into the designated slots on the shelf supports. Ensure they are fully seated and level.

   Illustration shows the shelves being slid into place on the assembled frame.
7. Step 7: Attach the Top Shelf/Tray

   Attach the top shelf or tray to the upper supports. This may involve sliding it into place or securing it with clips or fasteners as indicated.

   Illustration shows the top shelf or tray being attached to the upper part of the structure. A close-up shows the mechanism for attachment.
8. Step 8: Final Adjustments and Cable Management

   Adjust the feet to ensure the table is stable and level on your floor. Use the provided velcro straps to manage any cables, securing them neatly to the legs.

   Illustration shows the adjustable feet being turned to level the table. Another illustration shows velcro straps being used to secure cables to the legs.

Care and Maintenance

Wipe clean with a damp cloth. Check all screws periodically and retighten if necessary.