AutoWand™ User Manual
1. Enter Setting Mode
The motor will automatically leave setting mode if there is no action for 10 seconds.
Action: Press SET for 1 second.
Result: Motor will jog once when entering setting mode.
[Visual Description: A hand is shown pressing a button on the end of a yellow motorized rod. An arrow indicates the motor's action, showing a jogged rotation of the roller.]
2. Switch Direction
Use this function only if the direction of movement is reversed.
Action: In setting mode, press DOWN.
Result: Motor will jog once after direction is switched.
[Visual Description: A hand is shown pressing a 'DOWN' button on a remote-like device. An arrow points to the motorized roller, indicating the motor's action after the direction change.]
3. Set Upper and/or Lower Limit
Action: Press SET on the bottom of the handle.
Result: Motor will jog once after entering limit setting mode.
Action: Press UP to set the Up limit.
Action: Or Press DOWN to set the Down limit.
Action: Adjust shade to the desired position, then Press SET on the bottom of the handle again.
Result: Motor will jog once when the limit is saved.
[Visual Description: A sequence of diagrams illustrates: pressing SET on the handle, the motor jogging, pressing UP for the upper limit, pressing DOWN for the lower limit, adjusting the shade, pressing SET again, and the motor jogging to confirm the saved limit.]
4. Set Favorite Position
(Optional setting: The shade will stop at this additional saved position each time the shade is raised or lowered)
Action: Adjust shade to the desired Favorite position.
Action: Press SET on the bottom of the handle.
Result: Motor will jog once after entering Limit set mode.
Action: Press SET on the bottom of the handle again.
Result: Motor will jog once when the Favorite position is saved.
[Visual Description: A sequence shows adjusting the shade to a preferred position, pressing the SET button, the motor jogging, pressing the SET button again, and the motor jogging to confirm the saved favorite position.]
5. Erase all Limits
Action: Press SET on the bottom of the handle for 7 seconds.
Result: Motor will jog once after the button is pressed.
Result: Motor will jog again to indicate that the limits are erased.
[Visual Description: A hand is shown pressing and holding the SET button on the bottom of the handle for 7 seconds. The motor then jogs once, followed by a second jog, indicating that all limits have been successfully erased.]
