Onn. Wireless On-Ear Headphones Quick Start Guide

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. (3) The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Warning

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Need help? We're here for you every day from 7 a.m.-9 p.m. CST. Give us a call at 1-888-516-2630

Produced for Walmart Inc. Bentonville, AR 72716

Ver. 02 20/10/22

FCC ID: 2ADZH-ONN702901

We'd love to hear from you

Scan with your smartphone camera and let us know what you think.

Get to Know Your Wireless Headphones

• Model: 100070290
• Speaker Rated Input Power: 10mW
• Speaker Diameter: 30mm
• Speaker Impedance: 32Ω ±15%
• Speaker Sensitivity: 96dB ±4dB
• USB-C Charging cable: 6 ft (1.8 m)

What's in the Box?

Check to make sure you have everything below:

1. 1 Wireless On-ear Headphones
2. 1 USB C Charging Cable 6 ft (1.8m)
3. 1 Quick Start Guide

01 Let's Get Started! First Time Setup

Pairing

Step 1: Press and hold for 5 seconds to begin pairing. The LED will alternatively flash blue and red.

Step 2: Open Bluetooth setting on your device and select "onn. HEADSET" to get it connected.

Power On

Press & Hold 3 sec, LED light turns blue [?].

Power Off

Press & Hold 4 sec, LED light turns red [?].

Reset

Restore factory defaults [⚙️].

02 Dual-Point Connectivity

Connect two devices simultaneously.

1. To pair the headset with two devices, begin by connecting the headset to one device using the previous instructions. Once device #1 is connected, disable Bluetooth on the paired device #1 and the headset will automatically re-enter pairing mode.
2. Place device #2 into pairing mode and connect to device #2.
3. Re-enable Bluetooth connection on device #1 and the headset will automatically connect to both devices. Now your headset can be used simultaneously with two devices.

03 Enjoy Your Music

• Next Song: Press and hold for skip forward.
• Previous Song: Press and hold for skip backward.
• Volume Up: Press once [⬆️].
• Volume Down: Press once [⬇️].
• Siri/Google Assistant: Press twice.

04 Take a Clear Phone Call

• Answer Call: Press once [?].
• Hang Up: Press once [?].
• Reject Call: Press and hold [?].
• Volume Up: Press once [⬆️].
• Volume Down: Press once [⬇️].
• Mute Switch: When muted, the indicator should show red [?].

05 Charge Your Headphones

• Headphones charging: Red light on [?].
• Headphones fully charged: Blue light on [?].
• Charging time: Approximately 2 hours [⏳].

Note: While charging, the headphones are inoperable. 5V 0.5A.

Available Colors

• Black
• Ice
• Vermillion