User Guide

Safety Precautions

[!] Always follow safety guidelines. The following symbols indicate potential hazards:

• [!] General warning for caution.
• [Sharp Blade] Warning: Blade is sharp and can cause injury.
• [Falling Object] Warning: Risk of falling objects.
• [Weather Protection] Indicates protection from elements (e.g., for storage).

Specifications

The Dahle 533 and 534 paper trimmers offer different cutting capacities:

Product Code: 00613-17229

Operating Instructions

Section 1: Basic Cutting Procedure

Step 1.1: Position Paper

Place the paper on the trimmer base, aligning the edge with the desired cutting mark on the ruler. Ensure the paper is flat against the base.

Step 1.2: Lower the Cutting Blade

Grasp the trimmer handle. Lower the blade assembly towards the paper. The blade is protected by a guard when not in use.

Step 1.3: Execute the Cut

Apply steady downward pressure on the handle to cut the paper cleanly. The blade should move smoothly through the material.

Step 1.4: Secure Paper (Optional)

For precise cuts or multiple sheets, engage the paper clamp. Slide the clamp into position over the paper and secure it to prevent shifting.

Step 1.5: Confirm Cut Quality

Lift the blade. Inspect the cut edge. A clean, accurate cut is indicated as 'O.K.' [OK].

Section 2: Adjustments and Maintenance

Step 2.1: Adjusting Blade Guide/Guard

To adjust the blade guide or guard, locate the relevant screws [Wrench Symbol]. Loosen them slightly to reposition the guide, then retighten.

Step 2.2: Securing Blade Assembly

Ensure the blade assembly is securely mounted. This may involve tightening specific screws [Wrench Symbol] to maintain proper alignment and cutting action.

Step 2.3: Blade Positioning Check

After adjustments, ensure the blade is correctly positioned and secured. The 'O.K.' [OK] indicator signifies correct setup.

Step 2.4: Tighten Adjustment Screws

Use the provided wrench [Wrench Symbol] to tighten any adjustment screws for the guides or blade mechanism, ensuring stability.

Step 2.5: Fine-tuning Paper Guides

Adjust the paper guides or fences as needed. This typically involves loosening screws [Wrench Symbol], moving the guide, and then retightening to set the desired paper position for cutting.

Step 2.6: Final Operational Check

Confirm all adjustments are secure. The trimmer should operate smoothly, and the cut should be precise and clean, marked as 'O.K.' [OK].

Contact Information

For inquiries or support, please contact:

Dahle North America, Inc.

49 Vose Farm Road

Peterborough, NH 03458

Tel: (800) 995-1379

Email: info@dahle.com

Website: www.dahle.com

Document Reference: 16200-22453 | 0224