Shelly Wave 1 Mini Z-Wave Smart Switch User and Safety Guide

Brand: Shelly

Read Before Use

This document contains important technical and safety information about the Device, its safe use and installation.

About the Device

The Device is a small form factor smart switch with potential-free contacts (dry contact). It controls the on/off function for one electrical appliance (with a load of up to 8 A AC or 5 A DC), such as a bulb, ceiling fan, IR heater, electrical lock, garage doors, irrigation system. It is compatible with switches (default) and push-buttons.

Diagram Description (Fig. 1): Illustrates the Shelly Wave 1 Mini device with its terminals labeled N (Neutral), L (Live, 110-240 V ~), SW (SW1) for switch/push-button input, O (O1) for load circuit output, and I for load circuit input. It shows a typical connection to a 110-240 V ~ power supply and a load. Power ratings are specified as max. 8 A / 2000W @ 240 V ~ and max. 5 A / 150 W @ 30 V ⎓.

Diagram Description (Fig. 2): Shows the device with the switch/push-button input terminal (S) and the load output terminal (O).

Safety Warnings

⚠️ CAUTION! Danger of electrocution. Mounting/installation of the Device to the power grid must be performed with caution, by a qualified electrician.
⚠️ CAUTION! Danger of electrocution. Every change in the connections must be done after ensuring there is no voltage present at the Device terminals.
⚠️ CAUTION! Use the Device only with a power grid and appliances that comply with all applicable regulations. A short circuit in the power grid or any appliance connected to the Device may damage it.
⚠️ CAUTION! Do not open the Device. It does not contain any parts that can be maintained by the user. For safety and licensing reasons, unauthorized change and/or modification of the Device is not permitted.
⚠️ CAUTION! The load current circuit must be secured by a cable protection switch in accordance with EN60898-1 (tripping characteristic B or C, max. 10A rated current, min. 6 kA interrupting rating, energy limiting class 3).
⚠️ CAUTION! No SELV/PELV circuits may be connected to the terminals of the inputs and outputs, including the extension inputs.
⚠️ CAUTION! Do not connect the Device to appliances exceeding the given max. load!
⚠️ CAUTION! Do not shorten the antenna.
⚠️ CAUTION! Connect the Device only in the way shown in these instructions. Any other method could cause damage and/or injury.
⚠️ CAUTION! Do not install the Device where it can get wet.
⚠️ CAUTION! Do not use the Device if it has been damaged!
⚠️ CAUTION! Do not attempt to service or repair the Device yourself!
⚠️ CAUTION! Before starting the mounting/installation of the Device, check that the breakers are turned off and there is no voltage on their terminals. This can be done with a mains voltage tester or multimeter. When you are sure that there is no voltage, you can proceed to connecting the wires.
⚠️ CAUTION! Do not allow children to play with the push-buttons/ switches connected to the Device. Keep the devices for remote control of Shelly Wave (mobile phones, tablets, PCs) away from children.

Recommendations

Place the antenna as far away as possible from metal elements as they can cause signal interference.
Connect the Device using solid single-core cables or stranded cables with ferrules. The cables should have insulation with increased heat resistance, not less than PVC T105°C (221°F).
For inductive appliances that cause voltage spikes during switching on/off, such as electrical motors, fans, vacuum cleaners and similar ones, an RC snubber (0.1 µF / 100 Ω / 1/2 W / 600 V ~) should be connected parallel to the appliance.

Technical Specifications

Parameter	Value
Power supply AC	110-240 V ~, 50/60 Hz
Power consumption	< 0.3 W
Power measurement [W]	No
Max. switching voltage AC	240 V ~
Max. switching current AC	8 A
Max. switching power AC	2000 W
Max. switching power DC	150 W
Max. switching voltage DC	30 V
Max. switching current DC	5A
Overheating protection	Yes
External protection	10 A, tripping characteristic B or C, 6 kA interrupting rating, Energy limiting class 3
Wireless protocol	Z-Wave
CPU	S800
Z-Wave® Mesh distance	Up to 40 m indoors (131 ft.) (depends on local condition)
Z-Wave® Mesh frequency band	868.4 MHz
Z-Wave® Long range distance	Up to 80 m indoors (262 ft.) or up to 1000 m outdoors (3281 ft.)
Z-Wave® Long range frequency band	864 MHz
Z-Wave® repeater	No (Long Range), Yes (Mesh)
Max. radio frequency power transmitted in frequency band(s)	< 25 mW
Size (H x W x D)	29x35x16 ±0.5 mm / 1.11x1.35x0.63 ±0.02 in
Weight	19 ±1 g / 0.65 ±0.04 oz
Screw terminals max torque	0.4 Nm / 3.54 lbin
Conductor cross section	0.2 to 2.5 mm² / 24 to 14 AWG (solid, stranded, and bootlace ferrules)
Conductor stripped length	6 to 7 mm / 0.24 to 0.28 in
Mounting	In-wall box
Shell material	Plastic
Color	Blue
Ambient temperature	-20°C to 40°C / -5°F to 105°F
Humidity	30% to 70% RH
Max. altitude	2000 m / 6562 ft.

Important Disclaimer

Z-Wave® wireless communication may not always be 100% reliable. This Device should not be used in situations in which life and/or valuables are solely dependent on its functioning. If the Device is not recognized by your gateway or appears incorrectly, you may need to change the Device type manually and ensure that your gateway supports Z-Wave Plus® multi-channel devices and Z-Wave® Long Range capability in case of Long Range devices.

Disposal and Recycling

Do not dispose of the product in household waste. Recycle the product to prevent environmental and health damage and to promote resource conservation. Dispose of the product at an appropriate waste collection point at your own responsibility.

Resellers, from which the Device was purchased are required to accept Waste Electrical and Electronic Equipment (WEEE) free of charge for proper disposal. Some electronic products may store personal data. The user is responsible for deleting this data before disposing of the Device. For deletion reset the Device to its factory settings.

Declaration of Conformity

Hereby, Shelly Europe Ltd. declares that the radio equipment type Shelly Wave 1 Mini is in compliance with Directive 2014/53/ EU, 2014/35/EU, 2014/30/ EU, 2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address: https://shelly.link/ShellyWave1Mini_LR-DoC

Manufacturer

Company: Shelly Europe Ltd.

Address: Shelly Europe Ltd, 51 Cherni Vrah Blvd., building 3, floor 2 and 3, Lozenetz Region, Sofia 1407, Republic of Bulgaria

Tel.: +359 2 988 7435

E-mail: zwave-shelly@shelly.cloud

Support: https://support.shelly.cloud/

Web: https://www.shelly.com

Changes in the contact data are published by the Manufacturer at the official website: https://www.shelly.com

Ordering Code: QTSW-0A1X8EU

	Shelly Wave 1: Z-Wave Smart Switch User Guide and Features Explore the Shelly Wave 1, a Z-Wave smart switch with potential-free contacts for controlling electrical devices. Learn about its features, installation, specifications, and Z-Wave integration.
	Shelly Wave 1 Mini Z-Wave Smart Switch User Manual and Safety Guide Comprehensive user manual and safety guide for the Shelly Wave 1 Mini, a Z-Wave smart switch with dry contacts. Learn about installation, specifications, operation, and safety precautions.
	Shelly Wave 1: Z-Wave Smart Switch User and Safety Guide Discover the Shelly Wave 1, a Z-Wave enabled smart switch with potential-free contacts for versatile home automation. This guide covers installation, operation, Z-Wave pairing, and technical specifications for smart living.
	Shelly Wave Pro 3 Z-Wave Smart Switch User Manual User and safety guide for the Shelly Wave Pro 3, a 3-channel DIN-rail mounted Z-Wave smart switch with potential-free contacts. Learn about installation, specifications, and safe usage.
	Shelly 1 Mini Gen3: Wi-Fi Smart Switch with Potential-Free Contacts - User Guide Comprehensive user and safety guide for the Shelly 1 Mini Gen3 Wi-Fi smart switch. Learn about installation, features, specifications, and safe operation of this potential-free contact relay.
	Shelly Plus 1 Mini Wi-Fi Smart Switch User and Safety Guide A comprehensive guide to the Shelly Plus 1 Mini, a compact Wi-Fi smart switch with potential-free contacts. Learn about its features, installation, safety precautions, specifications, and compliance.
	Shelly 1 Mini Gen3 Wi-Fi Smart Switch: User Guide and Specifications Comprehensive user and safety guide for the Shelly 1 Mini Gen3, a Wi-Fi smart switch with potential-free contacts, covering installation, features, specifications, and safety precautions.
	Shelly 1 Mini Gen3 Wi-Fi Smart Switch User and Safety Guide Comprehensive user and safety guide for the Shelly 1 Mini Gen3 Wi-Fi smart switch, covering installation, specifications, and safe operation. Learn how to connect and control electrical appliances remotely.