Thule Verse Bike Rack Instructions

Important Information

IMPORTANT: READ THE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP FOR FUTURE REFERENCE.

Symbols

• CAUTION (⚠️): Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
• Note (ℹ️): Indicates additional information that is useful for trouble-free and optimal use of the product.

Product Overview and Specifications

The Thule Verse is a hitch-mounted bike rack designed to carry two bikes. It is available for 2" and 1.25" hitch receivers.

Load Capacity

• 2" Hitch (903452): Max 60 lbs (27.5 kg) per bike, Max 120 lbs (55 kg) total.
• 1.25" Hitch (903453): Max 55 lbs (25 kg) per bike, Max 110 lbs (50 kg) total.

Vehicle Compatibility Notes

• WARNING! This carrier is not compatible with travel trailers/caravans, 5th wheels, or any bumper-mounted hitch receiver.
• For motorized RVs or van conversions with an overhang exceeding 230 cm (7.5 ft) from the center of the rear wheel, operate at 60% load capacity (40% total load reduction).
• Refer to definition 49 CFR 571.3 (c) "Motor home", National Highway Traffic Safety Administration, Department of Transportation for vehicle type clarification.

General Usage Guidelines

• Ensure bikes are properly secured and do not obstruct vehicle lights or license plates.
• Observe speed limits and road conditions.
• Maximum distance for travel with bikes: 300 miles (500 km).
• Bike Fitment:
• Wheelbase: 20" min and 29" max.
• Wheelbase: 1"-5" max.
• Wheelbase: 33" min and 53" max.

Installation Steps

Follow these steps to install the Thule Verse bike rack:

1. Step 1: Prepare the rack. Attach the frame arms as shown.
2. Step 2: Insert the rack into the hitch receiver.
3. Step 3: Secure the rack using the provided lock and key. Tighten to 7.5 lb ft (10 Nm).
4. Step 4: Attach the bike trays.
5. Step 5: Secure the bike frame to the rack using the adjustable straps. Ensure a snug fit.
6. Step 6: Secure the bike wheels using the wheel straps.
7. Step 7: Repeat for the second bike.
8. Step 8: Lock the rack to the hitch receiver.
9. Step 9: Attach the bike wheel straps.
10. Step 10: Tighten the bike frame clamps.
11. Step 11: Adjust the bike trays as needed.
12. Step 12: Secure the bike frame with the locking knobs.
13. Step 13: Secure the bike wheels with the straps.
14. Step 14: Ensure all connections are secure and bikes are stable.
15. Step 15: Lock the bike frame to the rack.
16. Step 16: Load the first bike onto the rack.
17. Step 17: Secure the first bike's frame and wheels.
18. Step 18: Load the second bike onto the rack.
19. Step 19: Secure the second bike's frame and wheels.
20. Step 20: Check for stability and ensure all locking mechanisms are engaged.
21. Step 21: Remove the rack from the hitch receiver when not in use.

Accessories

The following accessories are available for the Thule Verse:

• Thule Verse 2-bike add-on (903651)
• Thule lights and license plate kit (903670)
• Thule Verse bike repair holder (903680)
• Thule transport wheels (903690)
• Thule loading ramp foldable (933410)
• Thule One-Key System (compatible with various cylinder sizes: 450200 (x2), 450400 (x4), 450600 (x6), 450800 (x8))