Paul Neuhaus 835925 Smart Home Light

Product Overview

This document provides fitting and electrical connection instructions for the Paul Neuhaus 835925 Smart Home Light. It also details technical specifications and setup for the included radio remote control.

Technical Specifications

Included Components

• Paul Neuhaus 835925 Smart Home Light fixture
• Q-receiver unit
• Radio Remote Control (RRC)
• Mounting hardware (screws, etc.)

Fitting Instructions

Follow these steps to mount the light fixture to the ceiling:

1. Ensure the power supply is switched off at the main breaker before starting installation.
2. Identify the mounting points on the ceiling. The diagram shows a required clearance of 6mm.
3. Attach the mounting bracket (indicated by '1' in the diagram) to the ceiling using appropriate screws (indicated by '2' and '3').
4. Connect the Q-receiver unit to the power supply and the light fixture as shown in the electrical connection section.
5. Carefully lift the light fixture and align it with the mounting bracket.
6. Secure the light fixture to the bracket. The diagram shows a sequence of attaching the fixture after the bracket is fixed.

Diagram Description: The fitting diagram illustrates the process of mounting the light fixture to a ceiling. It shows a mounting bracket being fixed to the ceiling with screws (labeled 1, 2, 3). The fixture itself is then attached to this bracket. A dimension of 6mm is indicated.

Electrical Connection

Connect the light fixture to the 230V/50Hz power supply. The diagram shows the connection points for the Q-receiver.

1. Ensure the power is OFF.
2. Connect the main power supply wires to the Q-receiver unit. The diagram indicates connections for Live (L) and Neutral (N). The diagram shows 'L (b)' and 'N (a)' as input terminals on the Q-receiver.
3. Connect the Q-receiver output to the light fixture's internal wiring. The diagram shows the fixture's wiring connected to the Q-receiver.
4. The diagram shows components labeled '4' and '5' which are part of the fixture's internal wiring or mounting.
5. A QR code (labeled '7') is present, which will be excluded from the output.

Diagram Description: The electrical connection diagram shows how to wire the light fixture. It details connecting the 230V AC mains supply (Live and Neutral wires) to the Q-receiver unit. The Q-receiver then connects to the light fixture's internal wiring. Components labeled 4 and 5 are part of the fixture or its connection system. A QR code is visible but will be excluded.

Remote Control and Reset

Pairing the Remote Control

To pair the radio remote control with the Q-receiver:

1. Refer to the separate Q-remote control manual for detailed pairing instructions.
2. The diagram shows the Q-receiver unit and the remote control.
3. The general process involves activating the Q-receiver and then operating the remote control.

Resetting the Lamp to Factory Settings

To reset the light fixture to its factory default settings:

1. Switch the lamp ON and OFF repeatedly, 5 times.
2. The sequence is: ON (5-10 seconds), OFF (1-2 seconds), ON (1-2 seconds), OFF (1-2 seconds), ON (1-2 seconds).
3. After the sequence, the lamp will reset to its factory settings.

Diagram Description: The remote control section shows the Q-receiver and a remote. The reset section illustrates a sequence of 5 on/off cycles with specific timing intervals (5-10 seconds, then 1-2 seconds for subsequent cycles) to perform a factory reset.