DL Flower Instruction Manual

Specifications

• Chamber Size: 0.25 g
• Battery Capacity: 1200 mAh
• Temperature Range: 320 - 430°F (160 - 221°C)
• Charging: USB-C

Kit Includes

• 1x DL Flower
• 1x USB-C Charging Cable
• 1x Cleaning Brush
• 2x Mouthpiece Screens

Charging

Before using the DL Flower, fully charge the device using the USB-C charging cable and a standard charging brick. The battery indicator lights will flash while charging and represent the battery level. When the battery reaches 100%, the device is fully charged, and the indicator lights will turn off. The device does not have pass-through functionality.

Battery Indicator

• 4 lights: 75 - 100%
• 3 lights: 50 - 75%
• 2 lights: 25 - 50%
• 1 light: 0 - 25% (Charge)

Loading the Chamber

With the device off, remove the mouthpiece. Fill the chamber to the top with finely ground material. It should fill the chamber completely, but not be packed too tightly. Approximately 0.25 g should be enough. Replace the mouthpiece once the chamber is packed.

Power On/Off

To power the device on or off, quickly press the button 5 times. The device will vibrate to indicate it is turning on or off. It will automatically start heating once it has been turned on.

Temperature Selection

The DL Flower has a temperature range of 320 to 430°F (160 - 221°C). Use the up and down buttons to select your preferred temperature in increments of 5 degrees. The device will vibrate once the selected temperature is reached. You can increase or decrease the temperature at any time during the session. The device will vibrate again to indicate the new temperature has been reached. To convert the temperature readout to Celsius, hold the power button and the down button simultaneously for 2 seconds.

Vaping Session Timer

To adjust the session duration, hold down the power button for 2 seconds when the device is on. You can adjust the session duration between 3 minutes (180 seconds) and 5 minutes (300 seconds) in 30-second increments. The display will only show the number of seconds for the session. Please refer to the chart below for minutes:

• 180 seconds = 3 minutes
• 210 seconds = 3:30 minutes
• 240 seconds = 4 minutes
• 270 seconds = 4:30 minutes
• 300 seconds = 5 minutes

Vaping

Once the device hits the selected temperature, it will vibrate to indicate it is ready. Begin vaping. Longer, slower pulls are recommended for the best experience. After the session, use the included stir tool to stir the material or discard it once fully used. A countdown timer will appear when there are 20 seconds left in the session. You can cancel the session by pressing the power button 5 times and turning the device off.

Cleaning

To clean the main body and chamber, first remove the mouthpiece and set it aside. Use the included cleaning brush to remove any build-up in the chamber or surrounding area.

To disassemble the mouthpiece, press firmly against the mouthpiece so it passes through the outer shell. Remove the silicone housing, then remove the ceramic air path from the side of the housing. Finally, remove the silicone screen from the bottom of the housing. Use the cleaning brush to remove larger build-up before soaking the pieces in alcohol for at least 30 minutes, or until the build-up is no longer present. Allow all mouthpiece parts to dry completely before reassembly.

Warnings

Do not expose to extreme temperatures or direct sunlight. Do not drop the device or accessories. Do not drop or submerge in any liquid. Do not modify the electronics in any way. This device is intended for adults only. Do not sell or provide to minors. Keep all parts, concentrates, herbs, and liquids away from children and pets. This is not a medical device and is not intended to diagnose, treat, mitigate, cure, or prevent any ailment, disease, or other conditions. Consult a physician before use, especially if you suffer from heart disease or any other medical condition, or if you are pregnant or breastfeeding. Failure to follow any of these instructions could result in product damage, property damage, personal injury, and may void warranty. Visit PulsarShop.com for warranty information.