Matteo Pendant Light Installation Instructions

Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all instructions carefully before assembly, installation and use of this product. Please keep instructions for future reference.

Warranty

• This light fitting is covered by a 12-month warranty from the date of purchase, not the date of installation.
• The warranty will be void if the fitting is not installed by a licensed electrician.
• Please retain proof of purchase and evidence of installation by a licensed electrician.
• Warranty will be void if there is any damage due to improper usage or modification to the fitting.
• Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the warranty.

Installation Requirements

• Must be installed by a licensed electrician.
• All wiring and installation of the light fitting must adhere to local and national wiring rules, e.g., AS/NZS 3000:2007/Amendment 2:2012 Electrical installations.
• Do not exceed the maximum wattage rating.
• Select a suitable location for installation:
  • This product is suitable for indoor use only.
  • The mounting point must support 2 times the weight of the fitting.
  • Ensure the fitting is not installed in the direct line of an air vent/system.
  • When installing a fitting in an area prone to moisture, ensure that area is well ventilated and an appropriately rated exhaust fan is used if required. Damage or corrosion caused by moisture is not a product fault and is not covered under warranty.
• Take care not to pull any electrical wires during unpacking as this may damage the connection.
• Lay out all the components on a smooth surface and ensure no components are missing before assembling. If parts are missing, return the complete product to the place of purchase for inspection or replacement.
• Check if the fitting has been damaged during transport. Do not operate or install any product that appears damaged. Return the complete product to the place of purchase for inspection, repair, or replacement.
• Ensure power to the circuit you are working on has been switched OFF before commencing any electrical work.

Installation Directions

1. Remove all packaging material from the product, being careful not to discard accessories hidden within. Lay the fitting on its side on a smooth, non-scratch surface to aid assembly.
2. Remove the mounting bracket (C) from the canopy (E).
3. Use the mounting bracket (C) as a template to mark the position of the holes onto the ceiling.
4. Drill holes into the ceiling and insert the plastic anchors (A). Secure the mounting bracket (C) to the ceiling using the provided screws (B). Ensure the screws are suitable for the mounting surface.
5. Connect the mains supply wire to the light fitting using the terminal block (D). Ensure wires are secure and no bare wires are exposed.
   • Mains Supply Wire: Earth - Yellow/Green, Neutral - Blue or Black, Live - Brown or Red
   • Fitting Wire: Yellow/Green or Blue, Brown
6. Secure the canopy (E) to the mounting bracket (C) by tightening the screws on the side (F).
7. Install the globe (G), (not included) into the lamp holder.
8. After installation, switch on the fitting to test and enjoy your new lighting product.

Diagram Description: The diagram shows the ceiling mounting of the pendant light. Components labeled A (plastic anchors), B (screws), C (mounting bracket), D (terminal block), E (canopy), F (side screws), and G (globe) are illustrated. The mains supply wires (Earth, Neutral, Live) are shown connecting to the fitting wires.

Safety Tips

• Always ensure the power is OFF and the fitting has cooled down before performing any maintenance, cleaning, changing the globe, or making adjustments.
• To avoid injury or damage to the fitting, ensure power leads and screws are secure before connecting power.
• Select a suitable location away from liquids and hazards.
• Ensure the fitting does not come into contact with corrosive chemicals.
• To clean, wipe with a damp, clean cloth. Never soak the fitting with water.

Specifications