551672 SBC LWP Low Passenger Side Alternator Bracket
Part Number: 551672
Description: SBC LWP Low Passenger Side Alternator Bracket
Manufacturer: ICT Billet
Made in the USA with USA made materials, spacers, pulleys, & tensioners.
WARNING: Cancer and Reproductive Harm
This product can expose you to chemicals including lead, which is known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
ALUMINUM: Most of the aluminum alloys used today contain some level of lead, usually less than 0.1%. Lead is known to the state of California to cause cancer and reproductive harm. Most aluminum alloys are physiologically inert in their solid form, and the lead is contained within; however, user-generated dust and/or fumes may pose a hazard if inhaled or ingested. Heating beyond a certain temperature may also provide avenues for exposure.
STEEL BOLTS: Steel is an iron alloy with several metals including Nickel and Chromium. Both Nickel and Chromium are known to the State of California to cause cancer and reproductive harm. This warning applies to stainless steels as well.
Installation Steps
Step 1
The diagram illustrates the initial mounting of the bracket. It shows the bracket being positioned on the engine block. Two blue spacers, labeled "2.72" SPACERS", are shown being inserted. A green socket cap bolt, labeled "SOCKET CAP 3/8 X 5in", is depicted passing through the bracket and into the engine, indicating its use for securing the bracket. The scale on the left indicates approximately 1 to 3 inches.
Step 2
This step focuses on attaching the main bracket assembly. Two green socket cap bolts, labeled "SOCKET CAP 3/8 X 1in", are shown being inserted through the bracket and into the engine, securing the component. The scale on the right indicates approximately 30 to 80 mm.
Step 3
The diagram shows the installation of the alternator. A red alternator is positioned against the bracket. The assembly uses blue spacers, labeled "3.25" SPACERS", and green socket cap bolts, labeled "SOCKET CAP 3/8 X 6in", to mount the alternator to the bracket. The scale on the left indicates approximately 4 to 7 inches.
Step 4
This final step demonstrates adjusting the belt tension. The diagram shows the belt routed around the pulleys. The text "ROTATE ALTERNATOR TO ADJUST TENSION" is clearly visible. A bolt labeled "5/16 X 1in" is shown, implying it is used to pivot the alternator for tension adjustment. The scale on the right indicates approximately 100 to 180 mm.
Technical Information & Support
Website: www.ictbillet.com
Technical Support Email: sales@ictbillet.com
Technical Support Phone: 316-800-6959
