Harbor Breeze Mini Path Lights

Important Safety Information

WARNING/ADVERTENCIA

• Battery must be recycled properly.
• Do not dispose old batteries in household waste.
• Do not dispose batteries in fire or expose to excessive heat.
• Rechargeable battery only.

CAUTION/PRECAUCIÓN

Recommend wearing gloves while installing to protect from sharp stake.

Customer Support

Thank you for purchasing this HARBOR BREEZE product. For questions, problems, or missing parts, please contact:

Phone: 888-251-1003 (8 a.m. - 8 p.m., EST, Monday - Sunday)

Email: ascs@lowes.com

For more information, visit Lowes.com, search the item number, and refer to the Guides & Documents tab.

Before Assembly

The solar light needs to be charged in full sunlight for 8-12 hours to allow the rechargeable battery to reach maximum capacity.

Place the assembled Bollard Pathway Light on a carpeted or scratch-free work surface to avoid damage. Do not dispose of packaging materials until assembly is complete. Use the Component Parts List to identify and separate all pieces.

Troubleshooting Tips

If the light does not turn on at night:

• Ensure no cover, shade, or shadowing obstructs the solar panel from direct sunlight.
• Verify the installed location receives adequate sunlight and is away from other light sources (e.g., streetlights) that might prevent automatic activation.
• Confirm the switch is in the "ON" position for charging. The battery will not charge if the switch is "OFF".
• The battery may need replacement if it has reached the end of its lifespan.

Package Contents

• Solar Panel
• Solar Top
• Lampshade
• Stake

Assembly and Installation

Step 1: Take off the stake from the lampshade (turn counterclockwise to open).

Step 2: Reverse the stake.

Step 3: Insert the reversed stake into the lampshade.

Step 4: Turn the switch to the "ON" position.

Step 5: Push the stakes securely into the ground.

Battery Replacement

1. Use a screwdriver to loosen the four screws under the solar compartment cover.
2. Remove the old battery.
3. Insert one new Ni-MH AAA 1.2V rechargeable battery (not included).
4. Ensure correct battery polarity (+/-) is followed.
5. Replace the battery compartment cover.
6. Use the screwdriver to tighten the four screws under the solar compartment cover.

NOTE: Use the same rating and type of battery (Ni-MH AAA 1.2V rechargeable battery). Ensure correct polarity (+/-) is observed.

Caution: Battery must be recycled or disposed of properly.

Important: Use only Ni-MH AAA 1.2V rechargeable battery.

Federal Communications Commission (FCC) Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.