CASIO Watch User Manual

Important Precautions

Handle your watch with care to ensure its longevity. Avoid extreme temperatures, dropping the watch, or wearing the strap too tightly. Clean the watch and strap with a dry, soft cloth, or a damp cloth with mild detergent. Never use volatile solvents like gasoline or thinners. Store the watch in a dry place when not in use. Avoid contact with gasoline, cleaning solvents, spray cleaners, adhesives, paints, and similar chemicals, as they can damage seals, case, and finish. For watches with silk-screened straps, clean them carefully to avoid damaging the designs.

Battery Information

The battery installed at the factory may discharge during shipping and storage. If the display becomes dim, replace the battery at an authorized CASIO service center or dealer.

Water Resistance

The watch's water resistance is classified from I to V. Do not press buttons underwater, change time underwater, or unscrew the crown underwater. If exposed to saltwater, rinse thoroughly and dry. Avoid wearing leather-strap watches while swimming and limit their contact with water. For plastic straps, a white powdery substance may appear; this is harmless and can be wiped off. Sweat or moisture can damage plastic straps; clean them promptly. For fluorescent cases/straps, prolonged sun exposure or moisture can cause fading; wipe off moisture immediately.

Notes:

• Friction on surfaces with fluorescent paint may transfer the paint.
• Condensation may form inside the glass due to temperature changes; this is normal and not a defect.
• CASIO COMPUTER CO., LTD. is not liable for any damage arising from the use of these watches.

Water Resistance Definitions:

• I: Watch is not water resistant. Avoid all moisture.
• II WR (Water Resistant): Complies with ISO 2281. Brief contact with water is acceptable.
• III 5 Bar (50 Meters): Withstands water pressure equivalent to 50 meters. Suitable for showering and brief swimming.
• IV 10 Bar (100 Meters): Suitable for regular swimming and snorkeling.
• V 20 Bar (200 Meters): Suitable for scuba diving (excluding dives requiring helium-oxygen mixtures).

Watch Care

Never attempt to open the case or remove the back cover yourself. Replace the water-resistant gasket every 2-3 years. If moisture enters the watch, have it checked immediately by a dealer.

Operating Modes

Press button 'B' to cycle through modes: Timekeeping -> Countdown Timer -> Alarm -> Timekeeping.

Timekeeping Mode

Displays current time. Press button 'C' for 2-second display illumination.

Setting Current Time and Date:

1. In Timekeeping Mode, press and hold 'A'. Seconds will flash.
2. Press 'B' to select values to adjust: Seconds, Hour, Minute, 12/24 Hr Format, Year, Month, Day.
3. Press 'C' to reset seconds to 00. Press 'C' to increase other values. Holding 'C' increases speed.
4. For 12-hour format, 'P' indicates PM.
5. Press 'A' to return to Timekeeping Mode. The day of the week is set automatically with the date. Date range: January 1, 2000 to December 31, 2039.
6. If no buttons are pressed for a while, the watch automatically returns to Timekeeping Mode.

Countdown Timer Mode

Countdown can be set from 1 minute to 24 hours. An alarm sounds for 10 seconds when the timer reaches zero, and can be stopped by pressing any button. You cannot change the countdown time while it is running; press 'A' to stop, then 'C' to reset to the preset time.

Setting Countdown Timer:

1. In Countdown Timer Mode, press 'A'. The hour digits will flash.
2. Press 'D' to cycle through adjustable values: Hour, Minute.
3. Press 'C' to increase the value. Holding 'C' increases speed.
4. To set a 24-hour countdown, set the display to 0:00'00.
5. Pressing 'B' and 'C' simultaneously resets the initial value to 0:00'00.
6. Press 'A' to return to Countdown Timer Mode.

Using the Countdown Timer:

1. In Countdown Timer Mode, press 'A' to start.
2. Press 'A' to stop. Press 'A' again to resume.
3. Stop the timer and press 'C' to reset to the preset value. After reaching zero, the alarm sounds for 10 seconds and the timer resets to the preset value.

Alarm Mode

You can set three different daily alarms. When the set time is reached, the alarm sounds for 20 seconds. An hourly chime can also be activated.

Setting Alarm Time:

1. In Alarm Mode, press 'C' to start setting: Alarm 1 -> Alarm 2 -> Alarm 3 -> Hourly Chime -> Alarm 1.
2. After selecting an alarm, press 'A'. The hour digits will flash, setting the alarm time.
3. Press 'B' to cycle through values: Hour, Minute.
4. Press 'C' to increase the value. Holding 'C' increases speed.
5. The 12/24 hour format for alarms matches the format selected for Timekeeping Mode.
6. After entering hour and minute settings, press 'A' to save the alarm settings.

Enabling/Disabling Alarms and Hourly Chime: Press 'C' in Alarm Mode to cycle through alarm ON/OFF and hourly chime ON/OFF. Press 'D' to switch between alarm and hourly chime modes.

Checking Alarm Sound: Press and hold 'B' in any mode to check the alarm sound.

Day Count Mode

In this mode, you can track the number of days elapsed from a preset date.

Setting Year, Month, and Date:

1. Press 'C' to select the counter (Year/Month/Date, or Month/Date).
2. Press 'A'. The hour digits will flash.
3. Press 'B' to cycle through values: Year, Month, Date.
4. Press 'C' to increase values. Holding 'C' increases speed.
5. Press 'B' to enter the current date into the Day Count Mode.
6. Press 'A' to return to the previous mode.
7. When setting the year, enter only the last two digits (e.g., 15 for 2015). Date range: January 1, 1940 to December 31, 2039.

Technical Specifications

Accuracy: +/- 30 seconds per month.

Timekeeping Mode: Hour, Minute, Second, 12/24 Hr Format, Month, Day, Day of Week.

Calendar Mode: Auto calendar from 2000 to 2039.

Countdown Timer: Unit: 1 second. Range: 1 minute to 24 hours.

Day Count Mode: Counts days between a set date and current date (Year/Month/Day counter, Month/Day counter). Range: January 1, 1940 to December 31, 2039.

Alarm Mode: Three daily alarms, hourly chime.

Dual Time: Hour, Minute, Second. 12/24 Hr Format switching.

Other: Electro-luminescent backlight.

Battery: One lithium battery (CR1616 for Module 2182, CR2016 for Modules 2189, 2289). Approx. 3-year life with 2 seconds backlight use and 20 seconds alarm use per day.

Product Information

Product Name: Electronic/Electro-mechanical Quartz Wristwatches (Men's/Women's)

Brand: CASIO

Manufacturer: CASIO COMPUTER Co., Ltd.

Manufacturer Address: 1-6-2, Hon-machi 1-chome, Shibuya-ku, Tokyo 151-8543, Japan

Importer: OOO "Kasio", 127015, Russia, Moscow, Butyrskaya st., d. 77

Warranty Period: 1 year

Address for Claims: As indicated on the warranty card.