EverStart maxx
QUICK START GUIDE
JUS750CE
This Quick Start Guide is not a substitute for the Instruction Manual. Please refer to the Instruction Manual and your vehicle's User's Manual before use.
If you have any questions, call Customer Service at 1-877-571-2391.
Important Charging Instructions
- Immediately charge this unit for a full 40 hours upon receipt. This unit's internal battery is shipped in a partially charged state and must be fully charged before use.
- Fully charge the unit immediately after purchase, every 30 days and after each use. Lead acid batteries can lose charge over time. Regular recharging can optimize performance and battery life.
Unit Overview and Controls
The unit features a control panel with various functions:
- Air Intake/Outtake: Marked with 'AIR' and symbols for airflow direction.
- Compressor Controls: '+' and '-' buttons to adjust air pressure.
- USB Ports: For charging electronic devices. Press the USB button once to turn On/Off.
- LED Light: Press once to turn On/Off the integrated work light.
- Jump Starter Switch: Leave in the 'OFF' position while connecting jumper clamps. Activate the switch only after confirming correct polarity.
- Power Dial: Rotates from 'OFF' to 'ON'.
Indicators and Displays
The unit includes several indicators and displays:
- Battery Charge Level: Displays charge status (25%, 50%, 75%, 100%). Flashes when charging.
- Digital Display: Shows various information depending on the function (e.g., voltage, PSI). Refer to the Instruction Manual for details.
- Fault Indicator: Alerts to potential issues.
- Reverse Polarity Indicator: Alerts if jumper clamps are connected incorrectly.
- USB Power Indicator: Shows when USB power is active.
- Compressor Pressure Indicator: Displays the selected PSI.
- Voltage Indicator: Displays the battery voltage.
- Compressor On Indicator: Flashes when the air compressor is pumping.
Indicator Status Meanings
| Indicator | Solid Status | Flashing Status |
|---|---|---|
| [Battery Charge] | Unit is fully charged | Unit is charging |
| [USB Power] | USB power is ON | |
| [Compressor] | Compressor feature selected | Compressor feature is ON |
| [Jump Start] | Vehicle has started | Ready to Jump-start |
| [System Fault] | System fault detected* | |
| [Clamp Connection] | Correct Clamp connection | Reverse Clamp connection |
*Consult the Troubleshooting section of your manual for further information.
Reverse Polarity Alarm
When battery clamps are connected in reverse polarity, an audible alarm (continuous beep) will sound and the LCD screen will display the Reverse Polarity Indicator icon. DO NOT activate the jump starter. If this happens, carefully disconnect the clamps and re-connect with the proper polarity. Ensure that the grounded clamp has a firm and clean connection.
Using the Air Compressor
To protect from overheating, DO NOT use the Air Compressor for longer than 10 continuous minutes. Allow the unit to cool for a full 30 minutes before attempting to use again. Note that your compressor will store your last PSI setting in memory, making it easier to regularly top off your vehicle's tires.
USB Power Usage
- Press the USB button on the control panel.
- Plug the electronic device into any of the USB Ports and operate normally.
- The LCD screen will display the Voltage Indicator and the USB Power On icon.
