Tigertronics

This document provides the appropriate reference for your radio equipment, the SignaLink radio cable, and the SignaLink (Jumper) module necessary to use the SignaLink USB interface with your radio.

You can search this document for your radio model using your browser's "Search" function (CTRL-F), or simply scroll to navigate.

Radios are classified alphabetically by manufacturer and then alphanumerically. If your radio is not listed, please contact us, and we will confirm the necessary references.

Every effort has been made to ensure the information provided in this document is accurate. However, errors may sometimes occur, and it is simply impossible for us to know the specific characteristics of every available radio.

Please consider the following points when selecting reference numbers for your radio:

• The SignaLink USB comes standard with a USB cable and wires for creating the necessary jumpers according to your radio model.
• When multiple cable options are available, DATA, ACCY, or other rear panel connection types are listed in order of preference. If the SignaLink USB or radio cable reference is not noted as "DATA", "ACCY", "REAR", or "PACKET", it is intended for use with the radio's MIC (microphone) jack.
• If no Jumper module reference is indicated for your radio, or if you see "jumper by wire" indicated, you will need to configure the SignaLink using the plug-in jumper wires provided with the unit.
• If you see "Contact us for wiring information", please send an email via our contact form.
• Be sure to read all notes indicated for your radio, as they detail important requirements or restrictions for the radio.

SignaLink equipment is available in France at the www.Passion-Radio.fr store.

ADI

ALINCO

ANYTONE

AZDEN

BAOFENG / BTECH

BRIDGECOM

COMMRADIO

CONNECTING SYSTEMS

DRAKE

ELECRAFT

FLEX-RADIO

ICOM

ICOM Suite

The 13-pin accessory port of the IC-970 uses a non-standard pinout and CANNOT be used with our SLCAB131 Accy Port cable.

JETSTREAM

CCR

KENWOOD

KENWOOD Suite

**European models only.

All other TM-271 / TM-271A models must use the RJ-45 microphone jack.

KIRISUN

LAB599

LEIXEN

LUITON

MIDLAND

MOTOROLA

POWERWERX

PUXING

QYT

RADIODDITÉ

RADIO SHACK

RAYTHEON

RETEVIS

SAINSONIC

SGC

TEN-TEC

TYT

WOUXUN

XIEGU

YAESU

YOU KITS

Important Notes

1. This jack does NOT cut off the microphone when in use. If you connect the SignaLink to this jack, you must either lower the radio's microphone gain control or disconnect the microphone to avoid a "hot" microphone.
2. This jack is for HF use only. For VHF or UHF operation, you must connect the SignaLink to a different jack on the radio.
3. This jack is for FM use only. It does NOT support USB/LSB operation.
4. Requires Yaesu CT-164 adapter to convert the radio's mini-DIN 10-pin connector to a standard mini-DIN 6-pin connector. This adapter should be available from any authorized Yaesu dealer.
5. Requires Yaesu CT-141 adapter to convert the radio's mini-DIN 8-pin connector to a standard mini-DIN 6-pin connector. This adapter should be available from any authorized Yaesu dealer.
6. Requires Yaesu CT-131 adapter. This adapter should be available from any authorized Yaesu dealer.
7. This radio provides differential / balanced audio on the external speaker jack. You must use an external isolation transformer when connecting this audio output to the SignaLink, or you could damage the radio.