Fox Mini Micron X Receiver User Guide

Features

• Digital circuitry
• Low battery drain
• Multicolour (x4) LED
• Easy Micron registration
• Weatherproof sealed case - I-COM®

The receiver features an antenna, 4x multicolour LEDs, bivvy light indication, a high-quality cone speaker, an on/off/volume button, a lanyard connection, and a sync button. The battery cover is located at the bottom.

Fitting the Batteries

To fit or replace batteries:

1. Turn off the unit.
2. Slide the battery cover downwards away from the receiver until it can be removed.
3. Carefully remove the old batteries and insert new ones, ensuring correct polarity.
4. Align the battery cover within the channels on the receiver case and slide it towards the top until it engages positively.

On/Off & Volume Control

To turn the receiver on or off, press and hold the on/off/volume button for 2 seconds and then release. To cycle through volume settings, briefly press and release the on/off/volume button. Repeat until the desired level is reached.

Registration Mode

To register bite alarms with the receiver for the first time:

1. Switch the Mini Micron X Receiver ON.
2. Using a small pointed object, press the registration button on the back of the receiver until the leftmost LED starts to flash. Release the button.
3. Switch on each Micron in the desired order.
4. When complete, press the registration button again or switch the unit off.

Note: The registration process can be disrupted by proximity to other radio signals, such as wireless routers.

Low Battery Warning

When batteries are low, the LEDs will flash red every 2 seconds until new batteries are inserted. The LED color will revert to the last chosen color. There is no audible low battery warning. The receiver displays battery life upon being turned on:

• 4x Green LEDs: Full Charge
• 3x Green LEDs: Good Charge
• 2x Amber LEDs: Running Low
• 1x Red LED: Replace Batteries

If volume or LED performance decreases, change the batteries. Remove batteries during long periods of non-use.

Best Performance

Optimal range is dependent on conditions. To achieve best performance:

• Keep the receiver as high above ground as possible.
• Maintain a direct line-of-sight between the receiver and transmitter.
• Do not keep the receiver in the same pocket as a mobile phone or other electronic device.
• Ensure both receiver and alarms have good batteries.

Use the system responsibly. The Mini Micron X Receiver is designed for long range to maximize reliability at close range, not to encourage users to leave rods unattended.

Battery Requirements

The Mini Micron Receiver requires 2 x LR03 AAA 1.5V Alkaline batteries. Use good quality batteries for maximum life. To reduce the risk of battery leakage:

• DO NOT mix old and new batteries.
• DO NOT mix different battery types.
• Rechargeable batteries are NOT recommended.

Remove batteries if the receiver will not be used for extended periods.

Warnings

• DO NOT trigger LED or speaker near human or animal eyes and ears.
• Store out of reach of children and infants.
• Avoid dropping or subjecting the Micron to severe impacts.
• Use only recommended batteries and accessories.

Product Information

FOX, I-Com, and Micron are Registered Trade Marks. Fox International Group Ltd. declares that this Mini Micron X Receiver complies with essential requirements and other relevant provisions of the Radio Equipment Regulations 2017. The UK Declaration of Conformity can be found at www.foxint.com/home/support/declarations-of-conformity/. Patents: EP1668983. Operating frequency: 868.870 MHz. Designed and Developed in UK.