MiBoxer FUT089 8-Zone RGB+CCT Remote Controller
Product Features
This product utilizes the globally adopted 2.4GHz frequency and GFSK control method. It offers low power consumption, long transmission distance, strong anti-interference capabilities, and fast communication rates. It can control specified Mi-Light smart lights, adjusting color, color temperature, saturation, and brightness.
Technical Parameters
- Model No.: FUT089
- Voltage: 3V (AAA * 2PCS)
- Transmitting Power: 6dBm
- Standby Power Consumption: 15uA
- Transmission Frequency: 2400-2483.5MHz
- Modulation Method: GFSK
- Control Distance: 30m
- Size: 153mm x 47mm x 19mm
Products Key Diagram
The remote controller features a color ring for color selection and saturation/CCT control. A brightness slider allows for brightness adjustment. Buttons include Master ON/OFF, Zone ON/OFF (for up to 8 zones), Speed control (S-/S+), and Mode switching.
Diagram Key:
- Color Ring: Touch to change colors. In white light mode, adjust color temperature; in color light mode, change color saturation.
- Brightness Slider: Slide to adjust brightness.
- White Light Button (W): Press to get white light.
- Zone ON Button: Touch to turn on the linked device for a specific zone.
- Zone OFF Button: Touch to turn off the linked device for a specific zone.
- Mode Button (M): Dynamic mode switching button.
- Speed Down Button (S-): Lower the dynamic mode speed.
- Speed Up Button (S+): Accelerate the dynamic mode speed.
Grouping of Several Lights
An unlimited number of lights can be added to a zone on the 8-channel remote by linking them to different zones. This allows for flexible creation of different group combinations. The manual provides visual examples of grouping configurations.
Remark:
- Users can reprogram freely as needed. One remote can control countless lamps or controllers, but one lamp or controller can only be controlled by a maximum of four remotes.
- Ensure correct battery installation and controller power status (fully discharged) when reprogramming after switching off and on.
Linking & Unlinking
Linking Instructions:
- Switch off the light, wait 10 seconds, then switch it on again.
- When the light is on, short press any zone button 3 times within 3 seconds.
- The light will blink 3 times slowly, indicating successful linking.
If the light does not blink slowly, the linking failed. Switch off the light again and repeat the steps.
Unlinking Instructions:
- Switch off the light, wait 10 seconds, then switch it on again.
- When the light is on, short press the corresponding zone button 5 times within 3 seconds.
- The light will blink 10 times quickly, indicating successful unlinking.
Unlinking must be performed for the same zone used during linking. If the light does not blink quickly, unlinking failed. Switch off the light again and repeat the steps.
Attention
- The 8-zone remote controller is compatible only with specified Mi-Light products. Not all Mi-Light series products will work with this remote.
- If the indicator light blinks rapidly during use, replace the batteries promptly.
- Avoid using poor quality batteries to prevent leakage that could damage the remote controller.
- To improve touch ring sensitivity, avoid touching it while installing batteries. Wait 3 seconds after battery installation before using the remote. Reinstall batteries if the touch ring sensitivity is low.
- This 2.4GHz remote control system is a precise electronic product. Avoid using it in humid, high-temperature, dusty, or high-voltage environments. Store it in a dry, indoor location free from static electricity.
- Do not use the remote controller in areas with large metal surfaces or strong electromagnetic waves, as this can negatively affect the control distance.
The product is CE, UK, CA, and RoHS certified. Made in China.
