WoodandHearts Full-Storage Shelf

Scope of Application

This children's shelving unit is designed for the safe and convenient storage of books, toys, learning materials, and small personal items. It is intended for use by children aged 2 and up, encouraging independent organization and easy access to everyday essentials.

Recommended age: For children from 2 to 6 years old.

Maximum Load Capacity: 30 kg / 66 lbs.

Terms of Use

• Only for indoor use.
• For domestic use.
• Tighten the bolts every 2 months.
• Use not more than 1 rope accessory per time.
• A safety mat or soft landing area is recommended to minimize injury risks.
• The product has no expiration term, but replace the product or its details immediately if any damage occurs.
• 2 years warranty.

Note:

• Warranty does not apply if the product is damaged due to weather conditions, as it is for indoor use only.
• The manufacturer reserves the right to make structural changes to the product without prior notice, provided such changes do not affect the product's functionality, safety, and key features.
• In case of any inappropriate use or failure to comply with the instructions, the manufacturer and seller shall bear no responsibility, and the warranty shall not apply.
• Responsibility for any damage incurred by children during play on the furniture rests with the supervising adults. If a child is injured while playing with the product, please treat the wound and consult a doctor.

Safety Measures ⚠️

• The product must be assembled by an adult. Do not attempt assembly without following the manufacturer's instructions, as an improperly assembled product can be unstable and unsafe.
• In a disassembled state, the product contains small parts constituting a choking hazard for children. After assembly, ensure all screws and fastenings are securely tightened. Keep any spare screws out of the reach of children.
• To be used under the direct supervision of an adult only. Do not leave children alone with the product.
• Tighten the screws every 2 months and regularly check the product for signs of wear. Immediately stop using the product if it shows any wear.
• Do not exceed the maximum weight limit.
• Do not let children climb onto the construction; it is meant for storage, not climbing.
• Do not use on uneven and hard floors.
• Do not use the product if it has any visible damage or is positioned abnormally.
• Do not use the product on a wet or contaminated floor.
• Do not place near hazards: ensure the unit is located at least 2 meters away from windows, sharp corners, hard furniture, or any other hazard.
• Do not place the product close to sources of radiant heat or under direct sun rays.
• To ensure the stability of the construction and prevent tipping, securely anchor the structure to the floor with the anchors provided in the assembly kit.

Care and Maintenance

• To clean the item, wipe it with a damp cloth or wet wipes.
• Avoid excessive moisture, as water can penetrate into seams or microcracks and cause damage to wood. In case of spillage on the product, wipe it dry immediately.
• Do not use abrasive sponges, aggressive detergents, alcohol, or acetone.
• Do not leave the product outdoors or near heat sources (e.g., batteries, fireplaces).
• With the appearance of scuffs or fading, you can restore the finish by applying a layer of varnish or paint. Use the same water-based product that the unit was originally treated with. Clean the surface and lightly sand before re-coating.
• If the product is not used for a long time, store it in a dry room with moderate humidity (40-60%). Avoid storage in damp or uninsulated areas.

Assembly Instructions

Parts List

Step 1: Assemble the Upper Box and Drawers

Assemble the upper box by taking the base of drawers 2 and 3 (Part 8) and screwing the dividers (Part 6) to it using confirmats (Part a). Then, screw the back wall of drawers 2 and 3 (Part 9) to the dividers (Part 6) with confirmats (Part a). Screw the sidewalls of the upper drawer (Part 11) to the base of drawers 2 and 3 (Part 8) with confirmats (Part a). Finally, screw the front wall of drawers 2 and 3 (Part 7) to the previously assembled structure with confirmats (Part a). Use the hex key (Part b) for this step.

Assemble the middle and lower drawers in the same way, using their respective side walls.

Step 2: Attach Drawers to Side Panel

Screw the previously assembled drawers to the side panel (Part 1) using screws (Part f), holding them with the hex key (Part e). Fix the screw with the nut (Part c) from the other side, using the hex key (Part f).

Step 3: Attach Second Side Panel

Screw the second side panel (Part 1) to the previously assembled structure using screws (Part d), holding them with the hex key (Part e). Fix the screw with the nut (Part c) from the other side, using the hex key (Part f).

Disposal and Environmental Information

Dispose of the product in accordance with local waste regulations. Components can be recycled where applicable.

Manufacturer

Look for manufacturer information on the product packaging.

Contact Information

Phone: + 1 804-500-1025 (USA, EN) | + 38 050 067 71 15 (UA)

Email: unterstutzung@woodandhearts.de | support.official@woodandhearts.com

Website: woodandhearts.de | woodandhearts.com