Hama Power Strip with USB Charging

Introduction

Thank you for choosing a Hama product. Please read these instructions and information completely and keep them in a safe place for future reference.

Important Symbols and Notes

[Risk of electric shock]: Indicates a risk of electric shock from touching product parts carrying hazardous voltage.

[Warning]: Used to indicate safety instructions or to draw attention to specific hazards and risks.

[Note]: Used to indicate additional information or important notes.

Package Contents

• Power strip
• Operating instructions

Safety Instructions

• Use the product only for its intended purpose.
• Do not operate outside the specified power limits.
• Protect from dirt, moisture, and overheating; use in dry environments only.
• Do not use in damp environments or expose to splashing water.
• Discontinue use if visibly damaged.
• Do not bend or crush the cable.
• Do not drop or expose to major shocks.
• Always pull the plug directly to disconnect, never the cable.
• Keep out of reach of children.
• Dispose of packaging material according to local regulations.
• Do not modify the product; this voids the warranty.
• Intended for private, non-commercial use only.
• Intended for indoor use only.
• Do not use near heaters, heat sources, or direct sunlight.
• Use only under moderate climatic conditions.
• Do not use where electronic products are not permitted.
• Route cables to prevent tripping hazards.
• Never connect multiple units in series.
• Operate only on the supply network described on the type plate.
• [Risk of electric shock]: Do not open or operate if damaged. Do not use if AC adapter, cable, or mains cable are damaged. Do not attempt self-service/repair; use qualified experts.
• [Warning]: Operate only from an approved, accessible socket. Disconnect using the On/Off switch (or unplug). For multi-sockets, ensure total power consumption does not exceed rating. Disconnect if not using for prolonged periods.

Operation

Connection of Devices

• Before connecting, check if the charger's current delivery is sufficient.
• Ensure the total output of all connected devices does not exceed 18W.
• Refer to your device's operating manual for instructions.

Power Delivery

• Plug & Go: No manual setup required. Voltage and power adjust automatically.
• Your terminal device must support PD for efficient charging.
• Firmware variations may affect PD support.
• If no other instructions are given, connect your device to a USB charging port using a suitable USB cable.
• Connect the charger to a properly installed and accessible mains socket.
• Charging progress is displayed on your device.
• Disconnect the device from the charger when charging is complete or to interrupt it.
• Disconnect the charger from the mains.

Care and Maintenance

[Note]: Disconnect from mains before cleaning or prolonged non-use.

• Clean with a slightly damp, lint-free cloth; do not use aggressive cleaners.
• Ensure no water enters the product.

Warranty Disclaimer

Hama GmbH & Co KG is not liable for damage resulting from improper installation, use, or failure to follow instructions/safety notes.

Technical Data

Specifications according to Regulation (EU) 2019/1782

External Links

For more information, visit www.hama.com.