Hama Mini Charger, USB-C + USB-A, PD/QC 3.0, 2.0, 32W

Introduction

Thank you for choosing this Hama product! Please take your time to read the following instructions and information completely. Keep these instructions in a safe place for future reference.

Diagram Description

The diagram shows a Hama Mini Charger with two ports labeled "USB-C" and "USB-A". Lines connect these ports to representations of a smartphone and a tablet, indicating that the charger can power or charge these devices.

Explanation of Warning Symbols and Notes

• ⚡ Risk of Electric Shock: This symbol indicates a risk of electric shock from touching uninsulated product parts that may carry hazardous voltage.
• ⚠️ Warning: This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.
• ℹ️ Note: This symbol is used to indicate additional information or important notes.

Package Contents

• Charger
• These operating instructions

Safety Instructions

• Protect the product from dirt, moisture, and overheating; use only in dry rooms.
• Do not drop the product or expose it to major shocks.
• Do not operate the product outside the power limits specified in the technical data.
• Do not modify the device; doing so voids the warranty.
• Do not continue to operate the product if it is visibly damaged.
• Use the product only for its intended purpose.
• As with all electrical products, keep this device out of the reach of children.
• Do not use the product near heaters, other heat sources, or in direct sunlight.
• Route all cables to prevent tripping hazards.
• Do not bend or crush the cable.
• Always pull the plug directly when disconnecting the cable, never the cable itself.
• Dispose of packaging material immediately according to local regulations.
• The product is intended for indoor use only.
• Use the article only under moderate climatic conditions.
• Do not use the product in areas where electronic products are not permitted.
• Do not use the product in damp environments and avoid splashing water.
• Do not open the device or continue to operate it if it becomes damaged.
• Do not use the product if the AC adapter, adapter cable, or mains cable are damaged.
• Do not attempt to service or repair the product yourself; leave all service work to qualified experts.

Operation

Mains Voltage (100 - 240 V)

The charger is suitable for mains voltages of 100-240 V and can be used worldwide. A country-specific adapter may be necessary.

Connecting Devices

• Before connecting a device, check if it can be adequately supplied with the charger's current capacity.
• Ensure the power of the connected device does not exceed 32W (20W + 12W).
• Note the instructions in your device's operating manual.

Power Delivery / QC 3.0, 2.0

• ℹ️ Plug & Go: No additional software required, simply plug in and start. Voltage and power are adjusted automatically thanks to Power Delivery/QC 3.0, 2.0.
• For efficient and optimized charging, your terminal device must support the PD (Power Delivery) / QC 3.0, 2.0 function.
• Due to the large number of PD/QC-enabled devices with different firmware versions, the function may not be fully supported.

Charging Procedure

• Only operate the product from an approved socket, installed close to and easily accessible from the product.
• Disconnect the product from the power supply using the On/Off switch; if unavailable, unplug the power cord.
• If using a multi-socket power strip, ensure the total power consumption of connected devices does not exceed the strip's maximum throughput rating.
• Disconnect the product from the mains if not used for a prolonged period.
• If device manuals do not specify otherwise, connect your device to a USB charging socket using a suitable USB cable.
• Connect the charger to a properly installed and easily accessible mains socket.
• The charging process is displayed on your device.
• Disconnect the device from the charger to interrupt charging or when the device is fully charged.
• Then disconnect the charger from the mains connection.
• When charging built-in batteries, note the maximum charging times.

Care and Maintenance

• Only use soft, dry towels for cleaning.
• ℹ️ Note: Disconnect the device from the mains before cleaning and during prolonged periods of non-use.

Technical Data

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product, or failure to observe the operating instructions and/or safety notes.