OK Series Mounting Profile Installation Guide
Optional OK Mounting Profile Items
| Item | Part Description |
|---|---|
| 1 | Single Mounting Profile (STK, SCK) |
| 2 | Double Mounting Profile (DTK, DCK) |
| 3 | Triple Mounting Profile (TTK, TCK) |
| 4 | Cage Nut |
| 5 | M6 Fastener |
Mounting Profile Assembly
Tools Required: Driver or Screwdriver, 10mm extended socket or T30 Hex Bit
- The single, double, and triple mounting profiles are available in two types: Expressed with a corresponding suffix; open flange (TK) and closed flange (CK).
- These profiles can be mounted directly to the OK Frame or other compatible profiles.
Figure 1: A diagram showing the assembled OK Series frame with labels indicating DTK, STK, TCK, TTK, SCK, and DCK profiles.
Closed Flange Assembly (CK)
- Insert a cage nut (Item 4) into the selected rail cutout on both sides the closed flange profile will attach to. For double or triple profiles, additional cage nuts are required.
- From inside the profile, fasten using an M6 screw (Item 5) into the previously installed cage nut (Figure 2).
Figure 2: A close-up view of a mounting profile attached to a frame, showing the placement of a cage nut (1), M6 screw (5), and fasteners (3, 4).
Open Flange Assembly (TK)
- Align and insert the open flange tabs into the corresponding cutouts on the frame or compatible profiles.
- Slide the profile downward until fully seated (Figure 3).
- Secure the profile using M5 self-tapping screws through the circular cutouts in the frame or compatible profiles.
Figure 3: An illustration showing the steps for attaching an open flange profile to a frame, including inserting tabs and securing with screws.
