HOT TUB COVER

MODEL: YD4.5ft/YD5.4ft

[Image: A circular, white, inflatable hot tub cover with concentric ribbed patterns, shown for reference only.]

Technical Support and E-Warranty Certificate

www.vevor.com/support

This is the original instruction. Please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. VEVOR will not provide notification for any technology or software updates on its products.

IMPORTANT SAFEGUARDS

WARNING: Read and understand this entire manual before operating or servicing this product. Failure to follow these warnings and instructions can cause personal injury or damage to valuable property.

• Avoid children using the hot tub cover. This product is not a toy. Do not allow children to play with it. Keep away from children in case of possible suffocation.
• Keep away from sharp points, blades, and other items.
• Keep away from open flame. This product will ignite and burn if brought into contact with an open flame.

Installation Precautions

1. Proper Dimensions: Please measure the inner diameter of your hot tub before ordering, and order a cover that fits your hot tub.
2. Weatherproof: Perfect for protecting your hot tub from inclement weather. Our hot tub covers protect against falling debris, rain, snow, and more, keeping your hot tub safe and in good condition.

SAVE THESE INSTRUCTIONS

PACKAGE LIST

1 Cover*1, 2 repair patch*2, 3 Manual *1

SPECIFICATIONS

INSTALLATION

1. Upon receiving the goods, open the cardboard box and retrieve the product.
2. Lay out the product and unzip it, then use a low-pressure pump to inflate the hot tub cover. (0.8psi is recommended.)
3. Gently press the cover into the inside of the hot tub, and the top surface of the cover is roughly flush with the top surface of the hot tub.

Note: The inflation rate should be at least 95%, otherwise the size may be smaller.

PRECAUTIONS FOR USE

1. Avoid using a high-pressure rapid pump to inflate the bathtub cover, as too much pressure may cause it to burst. The inflation rate is 95%.
2. Be careful when placing the lid to avoid damage. Do not drag it on the ground or near pointed objects.
3. Protect against bad weather.
4. Wash with mild soap and water and avoid harsh chemicals or abrasive materials.

Manufacturer Information

Manufacturer: Shanghaimuxinmuyeyouxiangongsi

Address: Shuangchenglu 803nong11hao1602A-1609shi, baoshanqu, shanghai 200000 CN.

Import Information

Imported to AUS: SIHAO PTY LTD. 1 ROKEVA STREET EASTWOOD NSW 2122 Australia

Imported to USA: Sanven Technology Ltd. Suite 250, 9166 Anaheim Place, Rancho Cucamonga, CA 91730

Regional Representatives

UK REP: YH CONSULTING LIMITED. C/O YH Consulting Limited Office 147, Centurion House, London Road, Staines-upon-Thames, Surrey, TW18 4AX

EC REP: E-CrossStu GmbH Mainzer Landstr.69, 60329 Frankfurt am Main.

Technical Support and E-Warranty Certificate

www.vevor.com/support