Wicked Brick Display Case Instructions
For LEGO® Balrog Book Nook (10367)
Model: LDS765
Important Notes:
- All acrylic parts have protective film applied on both sides.
- Some pieces may appear with slightly translucent film; this will need to be removed before assembly.
- Ensure all engraved lines face outwards during assembly.
Parts List:
- Part 1: PRT1
- Part 2: PRT2
- Part 3: PRT3
- Part 4: PRT4
- Part 5: PRT5 (Etching only applicable for limited edition)
- Part 6: PRT6
- Part 7: PRT7
- Part 8: PRT8
- Part 9: PRT9 (if applicable)
- Part 10: CPT3 (5x packs)
- Part 11: CPT2 (1x pack)
Assembly Steps:
Step A: Apply Felt Pads
Apply felt pads to the back of part 2.
Diagram A shows part 2, a large rectangular acrylic panel. Arrows indicate applying small circular felt pads to the back surface.
Step B: Initial Assembly
Assemble parts 1 and 2, along with parts 8 and 9, following the indicated alignment and movement.
Diagram B illustrates the initial assembly. Part 1, a base panel, is shown. Part 2, another panel, is positioned above it. Arrows suggest placement and alignment. Parts 8 and 9 are also depicted, likely fasteners or connectors.
Step C: Place Collectible
Place your LEGO Balrog collectible onto the assembled parts.
Diagram C shows the assembled base structure. A silhouette of the Balrog collectible is placed on top. A red arrow indicates placing the collectible onto the assembled parts.
Step D: Final Assembly
Complete the display case by assembling the remaining acrylic panels (parts 3, 4, 5, 6, 7) around the base and collectible, and attach the top (part 10).
Diagram D displays the completed display case. It is a cube-like structure formed by acrylic panels (parts 3, 4, 5, 6, 7) on a base (part 1) and a top (part 10). The Balrog collectible is inside.
