Dell Hybrid Cloud System for Microsoft Cloud Platform System Standard Version 1.5.16 Support Matrix

Introduction

The Dell Hybrid Cloud System for Microsoft Support Matrix describes supported software and hardware for Dell Hybrid Cloud System for Microsoft.

ℹ️ NOTE: As of June 2020, Dell Technologies is no longer supporting or maintaining the Dell EMC Hybrid Cloud System for Microsoft or associated documentation. It is recommended to always use the latest available firmware. Microsoft updates are available through the DHCS Self Service Microsoft Update Tool located on the Drivers and Download page on the Dell Technologies Support site.

Compute Nodes

The Dell Hybrid Cloud System for Microsoft solution supports the following component driver and firmware versions for compute nodes:

Table 1. C6300 and C6320

Storage

⚠️ CAUTION: The following Dell EMC Enterprise SSD drives with firmware prior to D417 will fail at 40,000 power-on hours, resulting in possible data loss:

Solution: Dell EMC recommends immediately upgrading to firmware D417 (or newer) to prevent unexpected drive failures. See the Dell Hybrid Cloud System for Microsoft Release Notes or the Dell Hybrid Cloud System for Microsoft Patch and Update Guide.

The Dell Hybrid Cloud System for Microsoft solution supports the following component driver and firmware versions for storage hardware:

Table 2. R730 and MD14x0

Backup

Backup is optional. The Dell Hybrid Cloud System for Microsoft solution supports the following component driver and firmware versions for backup hardware:

Table 3. R730xd

Switches

The Dell Hybrid Cloud System for Microsoft uses Dell Networking S4048-ON, which is a 10/40GbE top-of-rack open networking switch. It is a high-density, 1RU 48-port 10GbE switch with six 40GbE uplinks and ultra-low-latency, non-blocking performance to ensure line-rate performance.

The solution supports the following firmware version:

Table 4. S4048-ON