Sencor SRD 1000SCL Emergency Radio
Package Contents
The package includes:
- 1x SRD 1000SCL device
- 1x USB-C charging cable
- 1x User Manual
Device Description
The Sencor SRD 1000SCL is an AM/FM emergency radio with multiple charging options and useful features.
Key components:
- 1. Telescopic antenna
- 2. Hand crank for charging
- 3. Flashlight button
- 4. Solar panel for charging / Reading light
- 5. Flashlight
- 6. FM / AM scale
- 7. Radio function indicator
- 8. Battery status indicator
- 9. SOS button
- 10. Battery charging indicator
- 11. Speaker
- 12. FM / AM switch
- 13. Rotary knob for radio power and volume control
- 14. Rotary knob for radio tuning
- 15. USB-A port for power bank function
- 16. USB-C port for charging the SRD 1000SCL device
First Use
Before first use, fully charge the internal battery of the SRD 1000SCL. Charging takes several hours. The fully charged battery is indicated by the LED with the '100%' label. Use the USB-C charging port for the initial charge. The operation of available functions is described in the following chapters of this user manual.
Charging
The SRD 1000SCL can be charged in three ways:
a) USB-C
Remove the rubber cover and connect the USB-C cable to the device. Use a charger with minimum parameters of 5V and 1A. After charging, disconnect the USB-C cable and securely close the connectors with the rubber cover.
b) Hand Crank
Pull out the crank. For first-time use or if the radio has not been used for over 60 days, turn the crank clockwise or counterclockwise for 3 to 5 minutes continuously to activate the built-in battery. If the battery is activated by cranking, it will be recharged.
c) Solar Panel
Place the SRD 1000SCL device so that sunlight directly hits the solar panel. Charging via the solar panel is not a primary charging source. Warning: Avoid prolonged charging in direct sunlight to prevent overheating and damage to the SRD 1000SCL device.
Power Bank Function
The SRD 1000SCL features a power bank function. Uncover the rubber cover and connect a charging cable to the USB-A connector to start charging your device. Cover the port again after charging. Warning: This is a supplementary function. Your mobile phone may not be fully charged from the SRD 1000SCL's built-in battery. The USB-A port does not support fast charging protocols.
Flashlight
Press the flashlight button to turn on or switch flashlight modes. There are 4 modes:
- a) Main LED - spot flashlight
- b) Side LED flashlight
- c) Main LED - spot flashlight and side LED flashlight
- d) Off
Reading Light
On the side with the telescopic antenna, there is a notch in the solar panel for your fingernail to flip open the solar panel. Flipping open the solar panel automatically turns on the LED reading light. Closing the solar panel to its original position turns off the light.
SOS
Pressing the SOS button will cause the device to emit an acoustic signal and flash the flashlight. Pressing the SOS button again will turn off the SOS function. Warning: Use this function only when necessary to call for help. The SOS function does not replace certified emergency equipment.
Radio
a) Turn the volume knob clockwise to turn on the radio and adjust the volume. The POW indicator will light up when the radio is on. To turn off the radio, turn the knob counterclockwise until a slight click is heard and the POW indicator turns off.
b) Use the "FM / AM switch" to select the FM or AM radio band. For better signal reception, extend and adjust the antenna.
c) Turn the "Radio tuning knob" to select your desired radio station.
IPX3 Protection
The device is protected against water spray. Water sprays the device at an angle of 60° vertically, at a rate of 10 liters per minute, and at a pressure of 80–100 kN/m² for 5 minutes.
Technical Specifications
| Radio FM | Frequency range: 87.5 MHz – 108 MHz |
| Radio AM | Frequency range: 530 kHz – 1600 kHz |
Emergency Radio
- Analog tuning with AM/FM radio
- 3 charging methods: Solar, hand crank, and USB-C
- LED lights: Flashlight and reading lamp
- Water resistance: IPX3
Sound
- Total output power (RMS): 1 W
- Frequency response: 950 Hz – 3.5 kHz
Reception
- Analog tuning with AM/FM radio
- FM 87.5-108 MHz
- Telescopic 360° antenna
Lights
- LED flashlight with 3 modes: Long distance, wide angle, combined mode
- Reading lamp with 12 bright LEDs
3 Charging Methods
- Hand crank (3 min. / 360° rotation = 25 min. radio playback)
- Solar charging from the solar panel (2 hours charging = 30 min. radio playback)
- USB-C charging port
Battery
- 2000mAh built-in rechargeable battery
- Radio playback time up to 25 hours at 50% volume
- Reading light operating time up to 10 hours
- Power bank function
Other
- SOS alarm function
- USB-C charging port
- Dimensions: 157 × 74 x 53 mm
- Weight: 0.2 kg
- Accessories: Charging cable, manual
Important Safety Information
Always ensure the device's input ports (No. 15 and 16 in the "Device Description" illustration) are sealed with the original rubber plugs. Make sure the plugs are not damaged. Never charge the device when it may come into contact with liquids. The device is intended for contact with clean water only, without any impurities. Avoid contact with contaminated or industrially treated liquids (e.g., soft drinks, sea/salt water, oils, etc.).
Disposal of Packaging and Used Equipment
Dispose of used packaging material at a designated waste collection point.
Disposal of Electrical and Electronic Equipment
This symbol on the product or in the accompanying documents means that used electrical and electronic products must not be disposed of with regular household waste. To ensure proper disposal, recovery, and recycling, take these products to designated collection points. Alternatively, in some EU countries or other European countries, you can return your products to your local retailer when purchasing an equivalent new product. By properly disposing of this product, you help conserve valuable natural resources and contribute to preventing potential negative impacts on the environment and human health, which could result from improper waste disposal. For further details, please contact your local authority or the nearest collection point. In case of improper disposal, fines may be imposed in accordance with national regulations.
For Business Entities in European Union Countries
To dispose of electrical and electronic equipment, please request the necessary information from your retailer or supplier.
Disposal in Countries Outside the European Union
This symbol is valid in the European Union. To dispose of this product, please request the necessary information on the correct disposal method from your local authorities or your retailer.
The product meets the requirements of the EU.
FAST ČR, a.s. hereby declares that the radio equipment type SRD 1000 SCL is in compliance with Directive 2014/53/EU.
The full text of the EU Declaration of Conformity is available at the following internet address: www.sencor.com
Changes in text, design, and technical specifications may occur without prior notice, and the right to change them is reserved.
The original version is in Czech.
Manufacturer: FAST ČR, a.s., U Sanitasu 1621, Říčany 251 01, Czech Republic
Warranty Conditions (Czech Republic)
The product packaging does not include a warranty card.
The seller provides the buyer with a warranty for the product for a period of 24 months from the date of receipt by the buyer. The warranty is provided under the following conditions. The warranty applies only to new consumer goods sold to consumers for normal household use. Claims for defects (complaints) can be made by the buyer either to the seller from whom the product was purchased or to the authorized service center listed below. The buyer is obliged to claim without undue delay so as not to worsen the defect, but no later than the end of the warranty period. The buyer is obliged to cooperate in the complaint process as necessary to verify the existence of the claimed defect. Only a complete and, for hygiene reasons, unsoiled product is accepted for the complaint process. In the event of a justified complaint, the warranty period is extended by the time from the moment the complaint is filed until the moment the repaired product is taken over by the buyer or the moment the buyer is obliged to take over the product after the repair is completed. The buyer is obliged to prove their right to claim (proof of purchase of the product, warranty card, proof of putting the product into operation).
The warranty does not apply in particular to:
- defects for which a discount was provided;
- wear and tear and damage caused by normal use of the product;
- damage to the product due to unprofessional or incorrect installation, use of the product contrary to the user manual, applicable legal regulations, and generally known and customary methods of use, as a result of using the product for a purpose other than that for which it is intended;
- damage to the product due to neglected or incorrect maintenance;
- damage to the product caused by its contamination, accident, or force majeure (natural disaster, fire, water ingress);
- malfunctions of the product caused by unsuitable signal quality, disruptive electromagnetic fields, etc. mechanical damage to the product (e.g., broken knob, drop);
- damage caused by the use of unsuitable media, fillings, consumables (batteries) or unsuitable operating conditions (e.g., high ambient temperatures, high humidity, shocks);
- damage, modification, or other intervention in the product performed by an unauthorized or uncertified person (service);
- cases where the buyer does not prove their right to claim during the complaint (when and where the claimed product was purchased);
- cases where the data in the submitted documents differ from the data stated on the product;
- cases where the claimed product cannot be identified with the product stated in the documents by which the buyer proves their right to claim (e.g., damaged serial number or warranty seal of the device, overwritten data in the documents).
Distributor:
FAST ČR, a.s., U Sanitasu 1621, 251 01 Říčany
Service Center:
FAST ČR, a.s., Technická 1701, 251 01 Říčany, tel: 323 204 120
FAST ČR, a.s., GLP Park Brno Holubice area, Holubice 552, 683 51 Holubice, tel: 531 010 295
An up-to-date list of service centers for the Czech Republic can be found at www.sencor.cz.
The original manual is in Czech; other language versions are created by respective translations.
