GE LED 5.5MM Lights - Indoor Use Only

IMPORTANT SAFETY INSTRUCTIONS

When using electrical products, basic precautions should always be followed including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
Do not use seasonal products outdoors unless marked suitable for indoor and outdoor use. When products are used in outdoor applications, connect the product to a Ground Fault Circuit Interrupting (GFCI) outlet. If one is not provided, contact a qualified electrician for proper installation.
This seasonal use product is not intended for permanent installation or use.
Do not mount or place near gas or electric heaters, fireplaces, candles or other similar sources of heat.
Do not secure the wiring of the product with staples or nails, or place on sharp hooks or nails.
Do not let lamps rest on the supply cord or on any wire.
Unplug the product when leaving the house, when retiring for the night, or if left unattended.
This is an electric product-not a toy! To avoid risk of fire, burns, personal injury and electric shock it should not be played with or placed where small children can reach it.
Do not use this product for other than its intended use.
Do not hang ornaments or other objects from cord, wire, or light string.
Do not close doors or windows on the product or extension cords as this may damage the wire insulation.
Do not cover the product with cloth, paper or any material not part of the product when in use.
This product is equipped with push-in type lamps. Do not twist lamps.
This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows, unplug the product from the outlet. Also unplug any additional strings or products that may be attached to the product. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the product. If the replacement fuse blows, a short-circuit may be present and the product should be discarded.
Read and follow all instructions that are on the product or provided with the product.

SAVE THESE INSTRUCTIONS

USE AND CARE INSTRUCTIONS

When the product is placed on a live tree, the tree should be well maintained and fresh. Do not place on live trees in which the needles are brown or break off easily. Keep the tree holder filled with water.
If the product is placed on a tree, the tree should be well secured and stable.
Before using or reusing, inspect product carefully. Discard any products that have cut, damaged, or frayed wire insulation or cords, cracks in the lampholders or enclosures, loose connections, or exposed copper wire.
When storing the product, carefully remove the product from wherever it is placed, including tree, branches, or bushes, to avoid any undue strain or stress on the product conductors, connections, and wires.
When not in use, store neatly in a cool, dry location protected from sunlight.

USER SERVICING INSTRUCTIONS

Replace the fuse.

Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
Using a flathead screwdriver, open fuse cover. Slide open the fuse access cover on top of attachment plug towards blades.
Remove fuses carefully.
Risk of fire. Replace fuse only with 3 Amp, 125 Volt fuse (provided with product).
Close fuse cover. Slide closed the fuse access cover on top of attachment plug.
Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that should not be removed. Discard product if the attachment plug is damaged.

Replace the lamp.

Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
Pull lamp and plastic base straight out of lampholder.
Replace lamp with only 3.3 Volt, 0.066 Watt, LED type lamp (provided with product). If the new lamp base does not fit in lampholder, follow the steps below step 3.

Remove the base of burned out lamp by straightening lamp leads and gently pull lamp out.
Thread leads of new lamp through holes in old base with one lead in each hole.
After lamp is fully inserted into base, bend each lead up, like other lamps in the light set so that the leads will touch the contacts inside the lampholder.

CAUTION:

This lighting string is rated 12 Watts (0.1 Amps), do not overload. If connecting to a lighting string that does not have a Wattage (W) rating {found on the tag within 6 inches of the plug} calculate the wattage as follows: Multiply the current (A) which is on the flag-type tag by 120. For Example: Lighting string is rated 120V, 60 Hz, 0.1 Amps. 0.1 X 120 = 12 Watts. Add the wattage of each light string together for a total of 24 Watts or less. (Do not exceed 24 Watts.)
a) Replace lamps only with 3.3 Volt, 0.066 Watt spare lamps provided with product. b) Risk of fire. This product does not contain lamp shunts, which allow the product to operate if one lamp burns out. Do not replace lamps with other than the spare lamps provided with this product.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

For questions and/or assistance, call customer service at 1-877-398-7337 or visit us on the web at www.geholidaylighting.com

FP-25 PRINTED IN CHINA

246 Spring Hill Road, Unit B, Trumbull CT 06611

GE is a trademark of General Electric Company and is under license by Nicolas Holiday Ltd.

	GE C3LED(I)-5.5MMa-50(0.1) Indoor LED String Lights: Safety and User Instructions Official safety, usage, and servicing guide for GE C3LED(I)-5.5MMa-50(0.1) 5.5mm LED string lights. Covers important precautions, care instructions, fuse replacement, and lamp replacement for indoor decorative lighting.
	GE 450L Constant-On String Lights: Safety, Use, and Warranty Information Comprehensive guide for GE 450L Constant-On string lights, covering important safety instructions, usage and care, fuse and bulb replacement, electrical specifications, and a 2-year limited warranty. Includes troubleshooting tips and customer support contact.
	GE 450 Light String Lights FPH-150/3F: Safety, Use, and Warranty Information Comprehensive guide for GE 450 Light (Model FPH-150/3F) seasonal string lights. Includes essential safety instructions, detailed usage and care guidelines, step-by-step fuse and bulb replacement procedures, electrical specifications, and a 1-year limited warranty from Nicolas Holiday Ltd. Ensure safe and proper operation of your holiday lighting.
	GE StayBright LED 288 Lights (Model 81902LO) - Indoor/Outdoor Use and Safety Instructions Comprehensive safety, usage, and care instructions for the GE StayBright LED 288 Lights (Model 81902LO), suitable for indoor and outdoor use. Includes FCC compliance information and contact details.
	GE LED 350 Lights: Safety, Use, and Care Instructions Comprehensive safety, usage, and care instructions for GE LED 350 Lights (Model 22028LO). Includes FCC compliance information and troubleshooting tips for indoor decorative lighting.
	GE LED 50L 5.5MM String Lights - Safety, Use, and Warranty Information Comprehensive safety instructions, usage guidelines, and a 3-year limited warranty for GE LED 50L 5.5MM string lights by Nicolas Holiday Limited.
	NHL Tree Model No. 24140LO LED 550 Lights - Safety and Use Instructions Provides essential safety instructions and use and care guidelines for the NHL Tree Model No. 24140LO LED 550 Lights, designed for indoor use only. Includes information on electrical safety, proper installation, maintenance, and FCC compliance.
	NHL Tree Model 24100LO LED 200 Lights - Safety and Use Instructions Comprehensive safety, usage, and care instructions for the NHL Tree Model 24100LO LED 200 Lights, including FCC compliance information and support details.