WORKPRO 5-in-1 Hand Riveter

Intended Use

The WORKPRO (W023022A) 5-in-1 Hand Riveter with 100 Rivets is designed to set aluminum, steel, and stainless steel rivets. It includes 5 interchangeable nosepieces that accommodate rivet sizes from 3/32-inch (2.4mm) to 1/4-inch (6.4mm).

Rivet Specifications

The riveter comes with 5 interchangeable nosepieces, easily located on either side of the tool. The available rivet sizes are:

• 3/32-inch (2.4mm)
• 1/8-inch (3.2mm)
• 5/32-inch (4.0mm)
• 3/16-inch (4.8mm)
• 1/4-inch (6.4mm)

Figure 1 illustrates the riveter with arrows indicating the placement of the nosepieces.

Operating Instructions

1. Open the riveter handles as far as they will go to install a rivet.
2. Place the desired size rivet into the corresponding size nosepiece (already installed).
3. With the handles spread wide, push the rivet into the pre-drilled hole and apply pressure on the rivet and application surface. Squeeze the handles together until the rivet head pops free from the mandrel.
4. If the rivet does not separate from the mandrel, re-spread the handles, slide the nosepiece against the rivet button, and squeeze again until the rivet separates from the mandrel.

Changing Nosepieces

1. Select the nosepiece size corresponding to the desired rivet size for your project.
2. Simply remove and replace the desired nosepiece on the head of the riveter. Store unused nosepieces safely on either side of the handles.

Figure 2 shows the process of changing a nosepiece, with an arrow indicating the direction of removal/insertion.

Adjusting the Head

Under normal conditions, no head adjustment is needed. If the tool jams, it is equipped with an adjustable head:

Simply twist the adjustable head of the riveter to clear the jam. The mandrel will fall out of the bottom of the riveter. See Figure 3.

Figure 3 shows two views of the riveter head: one labeled "Adjustable Head" and the other "Twist-Locking".

Warnings

• KEEP OUT OF REACH OF CHILDREN.
• DO NOT use the tool outside of its designed intent.
• DO NOT alter or modify the tool for any other purpose or use.
• DO NOT point a loaded hand riveter at another person or animal.
• Users/Bystanders: Always wear certified approved goggles to shield eyes.
• Only use accessories specifically designed for this tool.
• Improper use, operation, modification, and/or maintenance of this tool can result in serious injury or death.
• Select only the correct accessories of the correct size and design for the job you are attempting to perform. Refer to Figure 1 for more detailed information.
• Prior to and during usage, ensure your work area is clean, safe, well-lit, organized, and adequately equipped.