Zinus

Components

The following components are included:

• A: 2 pieces
• B: 1 piece
• C: 6 pieces
• D: 16 pieces
• E: 4 pieces
• F: 12 pieces
• G: 6 sets
• H: 2 sets

Assembly requires one 1pc Allen wrench and one 1pc wrench.

A visual representation of the assembled frame shows the placement of components A, B, C, D, E, and H. The frame consists of two main side supports (A), crossbars (B), slats (C and D), and end supports (E). Component H is a non-slip tape slat.

Assembly Instructions

1. Step 1: Assemble the end supports. Attach component A to component C using fasteners F. Repeat this process twice.
2. Step 2: Connect the side frames. Attach components A and C to component B. Use fasteners G to secure these connections. Repeat this three times.
3. Step 3: Attach the side rails. Connect component A to the assembled side frames.
4. Step 4: Install the crossbars. Place component D, 16 pieces, across the frame.
5. Step 5: Attach the end supports. Secure component E, 4 pieces, to the ends of the frame.
6. Step 6: Continue adding crossbars.
7. Step 7: Install the center support. Attach component H, 2 sets, which are non-slip tape slats, to the frame.
8. Step 8: Final placement of non-slip tape slats. The image shows the final placement of the non-slip tape slats (highlighted in red) on the frame.

Return Policy

Zinus encourages customers to contact their Customer Service organization directly if they wish to return a product before returning it to the retailer. Customer Service can address concerns and answer questions about the product.

To initiate a return or for assistance, please email customerservice@zinusinc.com or submit a request at https://support.zinus.com.

The item must be returned in good condition, in its original packaging, with all original proof of purchase, parts, and accessories. The return must be within the time frame specified by the retailer from whom the product was purchased.

For warranty information on your new product, please visit Zinus.com.