AirFly SE

Pairing AirFly with AirPods

Step 1: Turn on AirFly

Slide the ON/OFF switch upwards to turn on the AirFly. Upon first power-on, AirFly automatically enters pairing mode, indicated by blinking white and yellow lights. Proceed to Step 2.

Note: To re-pair or reset AirFly in the future, press and hold the Reset button for four seconds to enter pairing mode.

Tip: Pairing is easiest when Bluetooth is deactivated on the device previously used with your AirPods.

Step 2: Activate AirPods Pairing Mode

To activate pairing mode for your AirPods, first place them in the charging case. With the lid open, press and hold the button on the back of the charging case until the light blinks white.

Step 3: Successful Pairing

After successful pairing*, the light on the AirPods charging case will turn green, and the light on the AirFly will be solid white and turn off after 10 seconds. ✔️

*First-time pairing can take up to 90 seconds, but AirFly will remember your AirPods for future connections.

Step 4: Connect to Audio Source

Connect AirFly to any device with a standard headphone jack to listen to audio wirelessly.

Pairing AirFly with Wireless Headphones

Step 1: Turn on AirFly

Slide the ON/OFF switch upwards to turn on the AirFly. Upon first power-on, AirFly automatically enters pairing mode, indicated by blinking white and yellow lights. Proceed to Step 2.

Note: To re-pair or reset AirFly in the future, press and hold the Reset button for four seconds to enter pairing mode.

Tip: To simplify pairing, turn off Bluetooth on the device previously used with your headphones.

Step 2: Activate Headphone Pairing Mode

Put your headphones into Bluetooth pairing mode (refer to your headphone's user manual for specific instructions). ?

Step 3: Successful Pairing

After successful pairing*, the light on the AirFly will be solid white and turn off after 10 seconds. ✔️

*First-time pairing can take up to 90 seconds, but AirFly will remember your headphones for future connections.

Volume Control and Mute

To adjust the AirFly's volume, press the volume buttons (up "+" or down "-"). You can also press and hold the volume buttons (up "+" or down "-") to gradually increase (or decrease) the volume until the upper or lower limit is reached.

Muting AirFly

To temporarily mute the AirFly's audio, double-click the volume down ("-") button. The light will blink yellow continuously to indicate that the volume is muted. Double-click the volume down button again to unmute and return to the previous volume setting.

Battery Status Indicator

To check the AirFly battery status, double-click the volume up (+) button:

• 4 x yellow blinks = approx. 100%
• 3 x yellow blinks = approx. 75%
• 2 x yellow blinks = approx. 50%
• 1 yellow blink = approx. 25%

Turning AirFly On and Off

Use the switch on the side of the AirFly to turn it on or off. Slide up to turn on. Slide down to turn off. AirFly will automatically reconnect to your headphones when you turn it back on.

Reconnecting Headphones to Your Smartphone/Tablet

Once paired, AirFly remembers your AirPods/headphones and switches to them when the device is turned on. To use your AirPods/headphones with your smartphone or tablet again, first turn off AirFly. On your device, open Bluetooth settings and select your headphones from the list. The status will change from "Not Connected" to "Connected" once the headphones are successfully paired with your device.

Charging AirFly

To charge, simply connect the included USB-C to USB-A charging cable to AirFly and then to any powered USB port. AirFly will be fully charged within 2 hours. The internal battery lasts approximately 20 hours. It is recommended to fully charge AirFly before its first use. If your AirFly is low on power, it will blink yellow three times to indicate it needs charging soon. While charging, the AirFly light will be solid yellow. The yellow light turns off when fully charged. AirFly can remain plugged in and charging during use.

Tips & Tricks

1. If only one AirPod seems to be playing audio, turn AirFly off and on again. This will resynchronize AirFly and both AirPods should reconnect.
2. If you wish to pair new headphones with AirFly or are experiencing connection issues with your headphones, reset AirFly by holding the Reset button on the side of AirFly for 4 seconds. After resetting, AirFly will blink yellow 4 times and then enter pairing mode.

Status Light Guide

Regulatory Information

FCC Declaration

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ⚠️

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

ISED Declaration

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

The license-exempt radio apparatus contained in this device complies with Innovation, Science and Economic Development Canada’s license-exempt rules. Operation is permitted under the following conditions: (1) the device must not cause interference; (2) the device must accept any interference, including interference that may affect its function.

Safety Information

Battery Safety: ⚠️

• Discarding a battery into a fire or a hot oven, or mechanically crushing or cutting a battery, can result in an explosion.
• Leaving a battery in an extremely high temperature environment adjacent to an explosion or leakage of flammable liquid or gas.
• A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.

NBTC Declaration

This telecommunication equipment complies with the requirements of the National Telecommunications Commission.

RED (EU Declaration of Conformity)

Twelve South, LLC hereby declares that the radio equipment type, Model Number TS-2259, is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at our website: www.twelvesouth.com

Frequency range: 2402 - 2480MHz

Transmit power: 4dBm (conducted)

Have Questions? ❓

Visit twelvesouth.com or contact support@twelvesouth.com.

© 2022 Twelve South, LLC. All rights reserved.

1503 King St. Charleston, SC 29405 - USA

Recycling Information ♻️

For recycling information, please visit twelvesouth.com/recycle.

France (FR): This device, its accessories, cords, and batteries are recyclable. Dispose of at designated collection points in stores or waste disposal facilities. Find collection points at www.quefairedemesdechets.fr. Prioritize repair or donation of your device!

UK/CE Markings: Indicates compliance with UK and European standards.