Ubiquiti G5 PTZ Gang Box Mounting Plate Installation Guide

Step 1: Mount the Bracket

Attach the mounting bracket (g) to the wall or gang box using screws (a). Use a Phillips head screwdriver to secure the screws.

Visual Description: The diagram shows the mounting bracket (g) aligned with screw holes on a wall. Screws (a) are shown being inserted through the bracket into the wall. A close-up shows a Phillips head screwdriver being used to drive one of the screws (a).

Step 2: Prepare Wall for Template

Use the template (i) to mark drilling locations on the wall. Drill holes using a Ø5 mm (03/16") drill bit. Insert wall anchors (b) into the drilled holes, using a hammer if necessary. A pencil is used for marking, a drill for holes, and a hammer for anchors.

Visual Description: The diagram illustrates using a template (i) to mark points on a wall. A blue power drill with a Ø5 mm bit is shown drilling into the marked spots. Wall anchors (b) are then shown being inserted into the drilled holes, possibly with a hammer.

Step 3: Secure the Mounting Bracket

Secure the mounting bracket (g) to the wall by tightening the set screw (f) with the provided Allen wrench.

Visual Description: The diagram shows the mounting bracket (g) already attached to the wall. A set screw (f) is being inserted into a designated hole on the bracket using an Allen wrench.

Step 4: Attach the Adapter Plate

Align the adapter plate (k) with the mounting bracket (g) and attach it. Arrows indicate the correct alignment and attachment points.

Visual Description: The diagram shows an adapter plate (k) being aligned and attached to the mounted bracket (g). Blue arrows indicate the direction of attachment.

Step 5: Mount the Camera

Mount the camera unit (compatible with G5 PTZ or G5 PTZ Surface Mount) to the adapter plate using M4 screws (e). Use a Phillips head screwdriver to secure the screws.

Visual Description: The diagram shows the camera unit being mounted onto the adapter plate. Two M4 screws (e) are shown being inserted through the camera base into the adapter plate. A close-up shows a Phillips head screwdriver driving one of the M4 screws (e).

Compatibility:

This mounting plate is compatible with the Ubiquiti G5 PTZ and G5 PTZ Surface Mount cameras.

G5 PTZ Surface Mount