VÅGHÖJD LED Floor Lamp

Important Information

If the external flexible cable or cord of this luminaire is damaged, it must be replaced by a special cord or cord exclusively available from the manufacturer or their service agent.

The light source of this luminaire is not replaceable. When the light source reaches its end of life, the entire luminaire shall be replaced.

[Warning icon] If the external flexible cable or cord of this luminaire is damaged, it shall be replaced by a special cord or cord exclusively available from the manufacturer or his service agent.

[Warning icon] The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.

Parts and Tools

An illustration shows two figures. One figure is contemplating assembly with parts, indicated by a question mark [?]. The second figure is on the phone, seemingly contacting IKEA.

• 2x Screws
• 1x Screw
• 1x Allen Key [L-shaped tool]

Assembly Instructions

1. Insert the lower pole section into the base. Secure the pole by inserting screws and tightening them with the Allen key.

   [Diagram description: Shows the base, the lower pole section being inserted, and a close-up of using the Allen key to tighten screws.]

2. Assemble the main pole sections by inserting them into each other.

   [Diagram description: Shows two pole sections being joined together.]

3. Connect the upper pole section to the assembled pole.

   [Diagram description: Shows the upper pole section being attached to the rest of the pole assembly.]

4. Attach the lamp head assembly to the top of the pole. Secure it by screwing it into place.

   [Diagram description: Shows the lamp head being screwed onto the top of the pole, with arrows indicating the rotational movement.]

5. Secure the assembled pole structure. Insert screws and tighten with the Allen key.

   [Diagram description: Similar to step 1, showing securing the pole assembly with screws and the Allen key.]

6. Connect the power cable to the designated port on the lamp's base or pole.

   [Diagram description: Shows the power cable being plugged into the lamp's body.]

7. Adjust the lamp arm and head to the desired position. The lamp arm can pivot and the head can tilt.

   [Diagram description: Shows the lamp arm and head in various positions, indicated by dashed lines and curved arrows, demonstrating adjustability. Includes an information icon [info] and a balance scale icon [info].]

8. Connect the power adapter to the power input on the lamp.

   [Diagram description: Shows the power adapter being plugged into the lamp's power input.]

9. Install or check the light source (bulb). Ensure it is correctly seated. The diagram shows a screw securing the light source housing and icons indicating light on/off or dimming.

   [Diagram description: Shows a close-up of the lamp head where the light source is housed, with a screw for securing it. Icons show a light bulb with arrows indicating on/off or dimming functionality.]

10. Further adjustment of the lamp arm's reach and height.

    [Diagram description: Shows the lamp arm being adjusted for reach and height, with curved arrows indicating movement.]

11. Final adjustment of the lamp head's angle.

    [Diagram description: Shows the lamp head being tilted to different angles, with curved arrows indicating movement.]