SuperFish Twilight Sensor

General Instructions

Read this manual carefully before using this device. Keep this manual for future reference.

Use

Suitable for SuperFish LED lighting with applicable cable connection. For outdoor use.

Safety

• Always follow the safety instructions from the manual of the SuperFish LED lighting and these instructions to ensure safe operation. Failure to follow these instructions may endanger persons or the environment.
• Do not use the product if the device, cord, or plug is damaged. Return the device to your dealer for repair or recycling. A damaged cord or plug cannot be replaced; the device should be recycled.
• Be careful with the combination of water and electricity. Do not operate with wet hands. Dry hands before carrying out maintenance.
• Always switch off all devices at the mains supply before maintenance.
• This device can be used by children aged from 8 years and above, and persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, if they have been given supervision or instructions concerning the use of the device in a safe way and understand the hazards involved. Children shall not play with the device. Cleaning and maintenance of the device shall not be done by children without supervision.

Function

Twilight sensor: automatically switches the LED lighting on when the outside becomes dark and off when it becomes light.

Installation

Follow these steps for installation:

• Make sure the adapter is unplugged and disconnected from the LED lighting.
• Connect the long end of the Twilight Sensor cable to the adapter. Hand tighten the union nut to prevent moisture from entering.
• Connect the other end of the Twilight Sensor cable to the cable of the LED lighting and hand tighten the union nut.
• Insert the Twilight Sensor ground pin upright and almost completely into the ground, ensuring the sensor is not covered.
• Plug the adapter back into the socket.
• Test the system by covering the Twilight Sensor with your hand; the LED lighting should switch on.

Installation Diagram Description: The diagram shows the Twilight Sensor unit with its cable and a pointed ground pin. The sensor cable connects to an adapter unit, which then connects to the LED lighting cable. The ground pin is depicted being inserted vertically into the soil to secure the sensor.

Recycling

The recycling symbol ♻️ indicates that this product should not be disposed of with normal household waste. Instead, it must be handed in at an official collection centre (e.g., a recycling center) or returned to the dealer when purchasing a similar new product. Please follow the applicable rules in your country for the separate collection of electrical and electronic products. Separate collection and recycling are better for the environment, public health, and reduce waste.

Warranty

A 2-year manufacturer's warranty covers material and construction defects. Devices must be returned complete with all components, accompanied by an official proof of purchase confirming the purchase date for any warranty claims. Incomplete devices or those without proof of purchase are not eligible for warranty. After receiving and checking, the manufacturer will determine whether the device will be repaired or replaced. For a device repaired or replaced under warranty, the remaining time of the original warranty period applies. Carefully read the instructions on installation, use, and maintenance. Damage due to incorrect use, immersion in water, contamination, improper cleaning, or cable damage is not covered by the warranty. Always keep the proof of purchase; the warranty will be void without it!