Hinkley Lighting Fixture Assembly and LED Replacement Instructions

Assembly Instructions

Begin Here

For Junction Box Mounting:

1. To begin, remove the mounting plate (A) from the backplate (C) by removing the four screws (E) located on the side of the fixture.
2. Determine which knockouts (K) need to be removed to secure the mounting plate (A) to the junction box (J).
3. Use two 8-32 screws (not provided) (B) to secure the mounting plate (A) to the junction box (J).
4. Assemble the finial at the bottom of the fixture. Secure the lock ups (L) on top of the diffuser (D) and the finial (F).
5. Connect the black live wire (W) on the fixture to the supply wire inside the junction box (X) using the provided wire nuts.
6. Connect the white neutral wire (Z) on the fixture to the neutral wire inside the junction box (Y) using the provided wire nuts.
7. To ground the fixture, fasten the ground wire to the ground screw inside the mounting plate.
8. Attach the backplate (C) to the mounting plate using the four provided screws (E).
9. Line up the holes from the backplate (C), shade (G), and diffuser (D).
10. Screw in the ball knobs (H) into these holes so that the backplate, shade, and diffuser are all assembled.

For Non-Junction Box Mounting:

1. Knock out the four holes indicated in the diagram for non-junction box mounting.
2. For conduit mounting, knockout the ring around the wire entry (U).
3. Place the four wall anchors (N) into the wall in a square pattern. The four wall anchors should line up with the four knockouts.
4. Secure the mounting plate by placing screws (S) into the wall anchors.
5. Connect the black supply wire (X) on the fixture to the supply wire inside the junction box using the provided wire nuts.
6. Connect the white neutral wire (Y) on the fixture to the supply wire inside the junction box using the provided wire nuts.
7. To ground the fixture, wrap the ground wire around the ground screw inside the mounting plate.
8. Attach the bottom diffuser (D) using the lock up (L).
9. Attach the backplate (C) to the mounting plate using the four provided screws (E).
10. Line up the holes from the backplate (C), shade (G), and diffuser (D).
11. Screw in the ball knob (H) into these holes so that the backplate, shade, and diffuser are all assembled.

Replacement Parts

Note: XX denotes finish for part.

• 41103
• 41503
• 41603
• 41104
• 41504
• 41604

LED Replacement Instructions

Begin Here

1. To replace the LED, first ensure that there is no power to the fixture.
2. To remove the fixture from its mounted location, unscrew the four screws that hold the backplate to the mounting plate.
3. Disconnect both the supply and neutral wires connecting the fixture to the junction box or other power supply.
4. Remove the shade and diffusers from the fixture so that the LED is accessible. Refer to the Assembly Instructions for shade and diffuser removal.
5. Disconnect the neutral and supply wires connecting the LED to the fixture. This can be done by pushing down on the push-in connectors with a pen or small screwdriver and simultaneously pulling the wires out.
6. Remove the defective LED by removing the small screws that hold the LED board to the backplate.
7. To attach the new LED board, use the hex nuts and screws that were used to attach the previous LED to the backplate. The gray thermal pad that rested between the LED and backplate can be reused and should be placed between the new LED and backplate.
8. Reconnect wires from the fixture to the new LED. This can be done by pushing down on the push-in connectors with a pen or small screwdriver and simultaneously pushing the wires into the connectors.
9. Reassemble the shade and diffusers onto the fixture.
10. Remount the fixture to its original location and restore power.