Playback Sequence
Zero 88
Standard Mode
This mode allows playback of up to three programmed sequences, and the ability to start and stop sequences. Only one sequence can be active at a time.
To begin, select the 'Playback Sequence' option from the Sequences menu and press the ENT key. If no sequence is currently active, the screen will display:
Sequence: 1 ENT to start
If a sequence (e.g., Sequence X) is currently running, the screen will show:
Sequence: X ENT to stop
Use the cursor keys to select the desired sequence. The second line of the display indicates the current status of the selected sequence.
Starting a Sequence
Select the required sequence using the cursor keys and press the ENT key. The sequence will commence playback, sending a start sequence message to the network and executing memory/area messages at the appropriate times. Starting a sequence in a specific area will override any existing memory or sequence currently active in that area.
Stopping a Sequence
Select the sequence that is currently running using the cursor keys and press the ENT key. The sequence will cease playback, sending a stop sequence message to the network.
ChilliNet Mode
Similar to Standard Mode, this option enables playback of up to three programmed sequences, with the ability to start and stop them. Only one sequence can be active at any given time.
Select the 'Playback Sequence' option from the Sequences menu and press the ENT key. If no sequence is currently running, the screen will display:
Sequence: 1 ENT to start
If sequence X is currently running, the screen will display:
Sequence: X ENT to stop
Utilize the cursor keys to choose the desired sequence. The second line of the screen will show the current state of the selected sequence.
Starting a Sequence
Select the desired sequence using the cursor keys, then press the ENT key. The sequence will begin running. The dimmer transmits a start sequence message over the network and subsequently plays memory/area messages at the correct intervals. Initiating a sequence in an area will replace any memory or sequence currently being output by the dimmer for that area.
Stopping a Sequence
Select the sequence that is presently running in the dimmer using the cursor keys, then press the ENT key. The sequence will stop running. The dimmer transmits a stop sequence message over the network.
