Kit Components
- Three (3) Digital Circuit Boards
- Three (3) Smoked Acrylic Lenses
- One (1) Temperature Sending Unit (S8013)
- One (1) Pressure Sending Unit (S8434)
- One (1) Universal Speedometer Sensor (S9013)
- One (1) Mounting Kit
Installation Instructions
- Remove existing gauges from the bezel and housing.
- Install the new circuit board into the stock gauge housing using existing screws and provided nylon washers.
- Modify mounting posts if necessary and secure the circuit board.
- Install the black factory gauge bezel, smoked acrylic lenses, and clear stock lens.
Wiring Instructions
Detailed wiring instructions are provided for Ground (Black), Power (Red), Dimmer (Purple), Turn Signals (Grey), High-Beam (Brown), Brake (Tan), Oil Pressure (Orange), Water (Blue), Fuel (Yellow), and Tachometer (Green) connections. Ensure proper grounding and avoid routing wires alongside high-current sources.
For specific wiring details, consult the full documentation or contact Intellitronix Technical Support.
Digital Performance Speedometer
The Intellitronix dash panel features a Digital Performance Speedometer with odometer, trip meter, high speed recall, 0-60 time, and quarter-mile elapsed time. Calibration is possible for tire size, wheel size, and gear ratios.
Calibration
The speedometer is pre-set to 8,000 pulses per mile. Recalibration may be necessary if tire or gear ratios are changed. Follow the step-by-step calibration process outlined in the document, which involves driving a measured mile and using the recall button to set the correct pulse rate.
Technical Support
For assistance, contact Intellitronix Technical Support Monday - Friday, 9am to 5pm EST at (440) 210-7646 or support@intellitronix.com.
This product carries a limited Lifetime Warranty, covering replacement or repair at Intellitronix's discretion.
