Intellitronix DP7006 Installation Guide

Ford Fox Body Mustang (1979-1986)

This guide provides detailed instructions for installing the Intellitronix DP7006 digital dash kit in your Ford Fox Body Mustang, covering model years 1979 through 1986.

Part Number: DP7006

Important Safety Note: Always disconnect the vehicle's battery before beginning any electrical work.

Kit Components

The Intellitronix DP7006 kit includes:

• Digital Circuit Board (Speedometer, Tachometer, Fuel, Voltmeter, Water Temp, Oil Pressure Gauges)
• Smoked Acrylic Lens (Ensure protective film is removed from both sides before installation)
• Cutout Black Film Overlay
• Temperature Sending Unit (S8013)
• Pressure Sending Unit (S8868)
• Ford Speedometer Sensor (S9024)
• Mounting Kit (Spacers, Screws, Nuts)

Wiring Instructions

Proper grounding is crucial for the correct operation of the gauges. Ensure a secure connection to the vehicle's engine block for the main ground.

Wire Connections:

• Ground (Black): Connect to the vehicle's engine block.
• Battery (Red): Connect to a constant +12V power source, fused at 5 amps.
• Power (Pink): Connect to accessory +12V power from the fuse panel or wiring harness.
• Water Temp (Blue): Connect to the water temperature sending unit.
• Oil Pressure (Orange): Connect to the oil pressure sending unit.
• Dimmer (Purple): Connect to parking lights for automatic dimming.
• High-Beam (Brown): Connect to the high beam headlight circuit.
• Turn Signals (Grey with White/Black Stripe): Connect to the respective turn signal wires.
• Fuel (Yellow): Connect to the existing fuel level sending unit.
• Fuel Ground (Black/Yellow): Connect to the fuel sending unit housing for proper ground.

Refer to the detailed diagrams within the full manual for specific connection points.

Calibration and Settings

The speedometer is pre-calibrated but may require adjustment if tire size or gear ratio has been changed.

Speedometer Calibration:

1. Locate a measured mile.
2. Drive the vehicle over the measured mile.
3. At the end of the mile, press the push-button to register the pulse count.
4. The speedometer will then be calibrated to your vehicle's specific setup.

Programmable Tachometer Settings:

The tachometer can be programmed for the number of cylinders and RPM display range. Use the trip/cal button to navigate and set these parameters.

Performance Data

The Intellitronix dash kit can record and display performance data, including high speed, 1/4 mile ET, and 0-60 times. Follow the instructions to record and view this data.