Installation Instructions
Item#: 759-2-XX-L / 769-2-XX-L
Important Safety Information
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
Preparation
- Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
- Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
Installation & Assembly
Refer to Fig.1 and Fig.2 for visual guidance.
Diagram shows mounting plate (B) attaching to outlet box (A) with screws (C). Support cable (F) connects to plate (B). Fixture body aligns with clamping position (E) on plate (B).
Diagram shows wire connections:
- Fixture wire (Black or Smooth) connects to House wire (Black - Hot) using a wire nut (D).
- Fixture wire (White or Ribbed) connects to House wire (White - Neutral) using a wire nut (D).
- Fixture ground wire (Bare Copper) connects to House ground wire (Green) using a wire nut (D).
All wire connections should be secured with electrical tape for added safety.
- Attach mounting plate (B) to outlet box (A) (Not included) using the outlet box screws (C) provided.
- Attach support cable (F) to the slotted holes on mounting plate (B). Carefully allow the support cable (F) to support the weight of the fixture while wiring.
- Pull power supply wires out from outlet box (A). Connect the black supply wire to the black fixture wire using wire nut (D). Connect the white supply wire to the white fixture wire using wire nut (D). Connect the fixture ground wire and the supply ground wire together using wire nut (D). Wrap all wire connections with electrical tape for a more secure connection.
- Carefully tuck all wires and wire connections into outlet box (A).
- Raise fixture body and align tab to the clamping position (E) of mounting plate (B). Push upward and rotate to install until tightening.
Your installation is now complete. Return power and test the fixture.
IMPORTANT:
FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING AND INSTALLATION.
Care and Maintenance
- Use a clean, soft cloth to wipe the surface of the fixture.
- DO NOT use any cleaners with chemicals, solvents, or harsh abrasives.
Specifications
Dimming: Dimmable with ELV and/or LED compatible wall dimmer switches.
Certifications
The fixture is ETL Listed and certified by Intertek, and is recognized by the American Lighting Association.
[ETL Listed Mark] [Intertek Logo] [American Lighting Association Logo]
