Static Pegs Installation

Caution:

• The peg attachment is located near the rear brake rotor. DO NOT install immediately after riding as the brake rotor will be hot and could potentially burn you.
• When using footpegs, refer to your bike's user handbook and do not exceed the maximum recommended weight limit for your bike of 325 lbs.
• Avoid touching the brake rotor during installation as the oils on your hand will contaminate the rotor and cause it to squeak when in use.

Included Materials:

• Static Peg (x2)
• Anti-Rotation Bracket (x2)
• Socket Head Screw- M12 x 1.25mm Thread, 20mm Long (x2)
• 18-8 Stainless Steel Washers for M12 Screw Size, 13mm ID, 20mm OD (x2)

Tools Required:

• 10mm Hex Wrench

Installation Instructions:

1. Start with the bike stable and turn it off. Locate the peg attachment holes on each side of the frame near the rear wheel.
2. Slide one flat washer onto one of the socket head screws then insert the screw into the peg hole from the inside of the frame.
3. Hold the washer and bolt in the hole, feed the following components onto the screw in this order:
   • 1 anti-rotation bracket with the tab positioned under the attachment hole.
   • Flat washer
   • The footpeg can be installed and hand-tightened until the hex wrench is needed.
4. Now that all of the components are aligned, use the 10 mm hex wrench to tighten the peg into place.
5. Once the peg is fastened, repeat the process for the other footpeg.