Sealey TSTPG10.V2 Digital Tyre Pressure Gauge

Introduction

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble-free performance.

IMPORTANT: Please read these instructions carefully. Note the safe operational requirements, warnings & cautions. Use the product correctly and with care for the purpose for which it is intended. Failure to do so may cause damage and/or personal injury and will invalidate the warranty. Keep these instructions safe for future use.

Safety

⚠️ WARNING! Check your tyre pressures regularly. An under or over inflated tyre can add to your fuel consumption and cause additional wear. Both are dangerous.

❌ DO NOT use this product for applications outside of its intended use.

✔️ Read and follow ALL instructions before use.

Product Description

Ergonomically designed lightweight tyre pressure gauge. Features one-button operation with an LCD digital display and an illuminated nozzle. Read-out is available in bar, psi, kg/cm², or kPa. The range is 0-150psi (0-10.3bar). It has an auto-power-off feature and is compact, easily stored in a glove box. Powered by 1 x CR2032 and 3 x LR44 batteries (supplied).

Figure 1 shows the digital tyre pressure gauge with the ON/OFF button highlighted.

Specifications

Operation

Measuring Tyre Pressure (FIG.1)

1. Press the ON/OFF button to turn the tyre pressure gauge on. The gauge will display "0.0" on the LCD screen.
2. Place the nozzle of the tyre pressure gauge on the tyre valve you wish to measure. Ensure a good seal to prevent air from escaping.
3. Hold the gauge on the valve until the measurement display locks.
4. Remove the gauge to easily read the pressure reading.
5. To change units, press the button to cycle through the four available units (bar, PSI, kg/cm², kPA).
6. The tyre pressure gauge will automatically turn off shortly after use. Alternatively, hold the ON/OFF button to turn off.

Changing the Battery (FIG.2)

Figure 2 shows the rear view of the gauge and the battery compartment.

1. Remove the back cover using a screwdriver.
2. Remove the old battery and replace it with an equivalent. Ensure the battery is placed with the correct polarity.
3. Replace the back cover and screws.

Environmental Protection and Disposal

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories, and packaging should be sorted, taken to a recycling centre, and disposed of in a manner compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.

WEEE REGULATIONS: Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.

Battery Removal Information

Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd is required to inform potential purchasers of products containing batteries (as defined within these regulations) that they are registered with Valpak's registered compliance scheme. Jack Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.

Notes and Warranty

Note: It is Sealey's policy to continually improve products and as such, they reserve the right to alter data, specifications, and component parts without prior notice. Other versions of this product may be available. If documentation for alternative versions is required, please email or call the technical team on technical@sealey.co.uk or 01284 757500.

Important: No liability is accepted for incorrect use of this product.

Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.