SHIMBOL

Instruction Manual

Shenzhen ZO Video Technology Co., Ltd.

01 / Features

02 / Packing List

• 1. Transmitter * 1
• 2. USB Power Cable * 1
• 3. User Manual * 1
• 4. Sticker

03 / Product Description

Detailed view of the SHIMBOL TP Mini TX transmitter unit.

The device is a compact, rectangular unit with rounded edges. It features ports and controls on its sides and a battery plate on the back.

• 1. LED Display Status Light: Indicates the operational status.
• 2. Electric Quantity Button: Used to check the battery level. Four green lights indicate a full battery. When connected via USB, a green light indicates power.
• 3. Pairing Button: This button is for production mode and does not require user interaction for pairing.
• 4. Power Switch: Controls the power to the unit.
• 5. HDMI Output (TX): Port for transmitting video signal.
• 6. HDMI Input (TX): Port for receiving video signal.
• 7. USB Port: For power supply or potential firmware updates.
• 8. Battery Plate: Allows mounting of NP-F series batteries for power.

Note A: Pressing button 2 displays the battery level. Four green lights signify a full charge. A green light is also illuminated when the device is powered via USB.

Note B: The pairing button is set to production mode and does not require user pairing.

04 / Technical Parameters

The TP Mini TX's WIFI module operates as a WIFI Access Point (AP). Upon startup, the AP waits for the TP Mini RX WIFI module (which has been pre-paired with the TP Mini TX in the factory) to connect. Once the connection is established, the TP Mini TX transmits the video stream to the TP Mini RX.

Contact Information

Tel: +860755-21004986

URL: www.zeroone-video.com

Address: 2C, 2nd Floor, Building 6, Longbi Industrial Park, No.27 Dafa Road, Bantian Street, Longgang District, Shenzhen, Shenzhen ZO Video Technology Co., Ltd.

Compliance Marks: UKCA, FCC, CE, RoHS

FCC Statement

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

• (1) This device may not cause harmful interference, and
• (2) This device must accept any interference received, including interference that may cause undesired operation.

2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.