Paulmann MaxLED 1000 RGBW LED Strip Basic Set

Product Models and Key Specifications

This LED strip system is available in several configurations:

• Model 705.28: Driver 50VA, 1.5m cable
• Model 705.29: Driver 75VA, 3m cable
• Model 705.30: 2.5m cable

General Specifications:

• Energy Efficiency Class: Varies (A++, A, G indicated on packaging)
• IP Rating (Controller/Driver): IP20
• IP Rating (LED Strip): IP44 (Water Protection)
• Controller Battery: 1x CR2025 Li-Ion Battery (3V 150mAh)
• Expandability: Max. 4m / Max. 5.5m (depending on configuration)

Safety Instructions

Please read and follow all safety instructions before installation and use:

• Ensure electrical work is performed by qualified personnel if you are not experienced.
• Do not damage the luminaire during installation or component replacement.
• Refer to www.paulmann.com/symbols for detailed explanations of symbols used in this manual.
• Dispose of old equipment and batteries responsibly.

Installation and Operation

The MaxLED 1000 system is designed for straightforward installation:

Connections:

• Connect the LED strip to the controller.
• Connect the driver to the LED strip or controller as per the diagrams.
• Ensure all connections are secure.

Controller Functions:

The included remote controller allows for various lighting adjustments:

• Power: [Power On/Off] button.
• Color Control: Buttons for [Red], [Green], [Blue], [White] color selection.
• Mode Selection: Buttons for [Auto Mode], [Jump Mode] (e.g., JUMP3, JUMP7), [Fade Mode] (e.g., QUICK, SLOW, FADE7).
• Brightness/Speed Control: Use the slider or +/- buttons to adjust brightness or mode speed.

The system is expandable up to a maximum length, as indicated in the specifications.

Component Replaceability

The replaceability of components is as follows:

• End User Replaceable: Light source or operating device can be replaced by end users without permanent damage to the luminaire.
• Electrician Replaceable: Light source or operating device can be replaced by a qualified electrician without permanent damage to the luminaire.
• Not Replaceable: If the light source or operating device is not replaceable, the entire luminaire must be replaced.

Disposal Information

Electrical and Electronic Equipment: Do not dispose of this product with general household waste. It can be handed in at public collection points for waste disposal. Batteries and accumulators that can be removed without damage must be separated from the old device before submission to a collection point. Retailers are obligated to take back this product free of charge under § 17 Paragraphs 1 and 2 of the German Electrical and Electronic Equipment Act (ElektroG).

Personal Data: End-users of old equipment must ensure that personal data on the equipment to be disposed of is deleted.