ZS2313W, ZS2333W, ZS2323W LED Floodlights with PIR Sensor

Product Overview

This document provides technical specifications, installation, maintenance, and safety instructions for the EMOS ZS2313W, ZS2333W, and ZS2323W LED floodlights with integrated PIR motion sensors.

These floodlights are designed for fixed mounting on solid surfaces and offer adjustable detection range, time delay, and ambient light sensitivity.

Energy efficiency class: F

Specifications

PIR Sensor Features

Ingress Protection: IP44 (suitable for outdoor use)

PIR Sensor Specifications:

• Time-delay: Adjustable from min. 10 s ±5 s to max. 7 min ±1 min.
• Detection Angle: 120°
• Ambient Light Sensitivity: Adjustable from 10 lux to 2,000 lux.
• Detection Distance: Max. 8 m
• Detection Motion Speed: 0.6-1.5 m/s

PIR Sensor Settings:

• Detection Field Adjustment: The detection area can be adjusted by moving the motion sensor switch left or right.
• Detection Range Adjustment: Set the distance at which the sensor responds to movement using control A – SENS.
• Time-Delay Adjustment: Set the duration the light stays on using button B – TIME.
• Ambient Light Sensitivity Adjustment: Choose the luminosity level at which the sensor activates using button C – LUX.

Mounting and Installation

Mount the floodlight firmly onto a solid base, such as a wall (refer to figures 1, 2, 3). Installation height should be between 1.8-2.5 meters.

Connect the power cable to a 220-240 V~ power network. Ensure the cable is disconnected from the power supply during installation. Connection of the power cable to the spotlight should only be performed by a qualified person.

Direct the light beam as shown in figures 1 and 2.

Wiring:

• L (Live): Brown wire
• N (Neutral): Blue wire
• G (Ground/Earth): Green/Yellow wire

Maintenance Instructions

Before maintenance, switch off the floodlight and allow it to cool down. Clean with a soft, moistened cloth. Never submerge the floodlight in water or other liquids. Always observe general occupational safety rules and exercise caution during maintenance.

Important Warnings and Precautions

• The floodlight is designed for fixed mounting only.
• Maintain a minimum distance of 1 meter between the floodlight and any object or surface to be illuminated.
• If mounting under a roof or overhang, maintain a minimum distance of 0.2 meters from the top of the floodlight to the underside of the roof.
• Do not use the floodlight without its protective glass.
• Protection against dangerous contact voltage is ensured by earthing.
• The external flexible cable or cord cannot be replaced; if damaged, the luminaire must be destroyed.
• The light source is not replaceable; the entire luminaire must be replaced when the light source reaches its end of life.
• Ensure the electrical installation and circuit protection comply with applicable standards.
• Disconnect the floodlight from the power supply before any maintenance or service. This should only be performed by a qualified person.
• Caution: Risk of electric shock ⚡.

Compliance

EMOS spol. s r.o. declares that the ZS2313W, ZS2323W, ZS2333W complies with the essential requirements and other relevant provisions of the directive. The device can be freely operated in the EU. The Declaration of Conformity can be found at: http://www.emos.eu/download