Honda 2022 Pioneer 520 Front Light Bar
Rough Country UTV Accessories
Thank you for choosing Rough Country for your vehicle needs. Please read these instructions carefully before beginning installation. Verify the kit hardware against the kit contents listed below to ensure you have all necessary parts and understand their placement.
If you have any questions, please contact Rough Country at 1-800-222-7023. We are happy to assist with any inquiries regarding this product.
Ensure all fasteners are checked for proper torque and verify adequate clearance between all components. Periodically check all hardware for tightness.
Kit Contents
- 50" Single Row LED Light Kit x1
- Driver Side Brackets x1
- Pass Side Brackets x1
Tools Needed
14mm Wrench or Socket
Torque Specifications
| Size | Grade 5 | Grade 8 | Size | Class 8.8 | Class 10.9 |
|---|---|---|---|---|---|
| 5/16" | 15 ft/lbs | 20ft/lbs | 6MM | 5ft/lbs | 9ft/lbs |
| 3/8" | 30 ft/lbs | 35ft/lbs | 8MM | 18ft/lbs | 23ft/lbs |
| 7/16" | 45 ft/lbs | 60ft/lbs | 10MM | 32ft/lbs | 45ft/lbs |
| 1/2" | 65 ft/lbs | 90ft/lbs | 12MM | 55ft/lbs | 75ft/lbs |
| 9/16" | 95 ft/lbs | 130ft/lbs | 14MM | 85ft/lbs | 120ft/lbs |
| 5/8" | 135ft/lbs | 175ft/lbs | 16MM | 130ft/lbs | 165ft/lbs |
| 3/4" | 185ft/lbs | 280ft/lbs | 18MM | 170ft/lbs | 240ft/lbs |
Installation Instructions
Remove the front upper cage bolt using a 14mm socket. (Visual: A hand is shown removing a bolt from the UTV's front upper cage.)
Remove and retain the OE (Original Equipment) bolt from the cage. (Visual: A hand is shown removing an OE bolt from the UTV's cage.)
Place the removed bolt into the bracket, ensuring the 90-degree bends face toward the inside of the UTV. (Visual: A bracket is shown with a bolt inserted, illustrating the correct orientation for installation.)
Tighten the bolts using a 14mm socket. (Visual: A bracket is shown being secured to the UTV with a socket wrench.)
Repeat steps 1-4 on the opposite side of the UTV.
Place the 50" LED light bar in-between the installed light brackets. Secure using the supplied hardware from the lighting kit. (Visual: The 50-inch LED light bar is shown being positioned between the UTV brackets.)
Connect the light bar wiring harness to the UTV's power supply. Set the light bar to the desired angle. Then tighten the hardware using the corresponding tools with the light bar hardware. (Visual: The light bar bolts are shown being tightened to finalize the installation.)
Legal Disclaimer
By purchasing any item sold by Rough Country, LLC, the buyer expressly warrants that he/she is in compliance with all applicable, State, and Local laws and regulations regarding the purchase, ownership, and use of the item. It shall be the buyer's responsibility to comply with all Federal, State and Local laws governing the sales of any items listed, illustrated or sold. The buyer expressly agrees to indemnify and hold harmless Rough Country, LLC for all claims resulting directly or indirectly from the purchase, ownership, or use of the items.
