Moulinex Lightmix Blender
User Manual and Safety Guide
Important Safety Instructions
Read the safety instructions and booklet carefully before using for the first time.
To charge the rechargeable battery, use only a Class II power supply (not provided) approved for use with household appliances. SELV output: DC 5V, max. 1A (image 2.1).
Before using the appliance for the first time, fully charge the battery. The unit may become warm during the charging process.
The blender may only be used for its intended purpose according to these operating instructions. Therefore, carefully read the operating instructions prior to use. It provides instructions for using, cleaning and maintaining of the device. Moulinex does not assume any liability for any damage if the instructions are not observed. Keep the operating instructions well preserved and pass them on to the subsequent user together with the device. Also note the warranty information at the end. The device is not intended for commercial use, but rather only for the preparation of food in common household amounts. Observe the safety instructions during use.
Note: Electrical outlet not included. For charging, only use a 5V 1A charger, not a fast charge type.
Charging Status Indicators
- LED flashes white: Improper attachment (fig. 1.2)
- LED flashes red: Battery is empty
- Charging Mode (when the charger is connected):
- LED flashes red: Battery is charging
- LED flashes white: Battery is fully charged
Troubleshooting
| Symptom | Confirmation Matters | Take Steps |
|---|---|---|
| Product does not start | Is it used continuously for a long time? | Please wait for the motor to cool down before using. |
| Is the food stuck on the blade? | Please remove the remaining food and use it again. | |
| Is the lid and the mixing container not rotated in place? | Please install the lid and the mixing container in place before starting. | |
| The red light flickered | Please fully charge before use. | |
| When working, the blade is stuck and the lamp flashes | The fruits are too large and cause the blade to stop. | Fruits should be washed, peeled, pitted, and cut into 1cm*1cm*1cm small cubes. Put the soft fruits last into the container, so that they touch the blades first. |
| Fruits and liquids exceed the maximum scale rated by the product. | Reduce the liquid capacity so that it does not exceed the rated capacity of the container. | |
| No red light during charging | Bad connection of USB data line | Check the connection status of the USB data line to ensure that the connection is normal. |
Operating Instructions
- Preparation: Ensure fruits are washed, peeled, pitted, and cut into small cubes (approx. 1cm x 1cm x 1cm). For best results, add softer fruits last to ensure they contact the blades first. Do not exceed the maximum fill line of the container.
- Blending: Securely attach the lid and mixing container. Press the power button to start blending. The device is designed for short blending cycles (e.g., 40 seconds x 2 cycles).
- Stopping: Press the power button to stop blending.
Cleaning and Maintenance
After each use, disassemble the blender components. Wash the blade assembly, container, and lid with warm, soapy water. Rinse thoroughly and allow to air dry completely before reassembling. Do not immerse the motor base in water or any other liquid.
Warranty Information
Please refer to the warranty card included with the product for detailed warranty terms and conditions.
