AOBOSI Compressor Wine Cooler Instruction Manual

Introduction

This manual contains important safety and installation instructions for the AOBOSI Compressor Wine Cooler. Please read it carefully before use and follow all safety information and instructions. It is recommended to keep this manual for easy reference.

Contents

• Important Safety Information
• Structure and Installation Drawing
• Accessory Installation Before Operating
• Operating the Wine Cooler
• Care and Maintenance
• Troubleshooting
• Warranty

Important Safety Information

To avoid the risk of fire, electrical shock, or injury, follow these precautions:

• The appliance is intended exclusively for the storage of wine.
• Ensure your supply voltage matches the rating label. Use a grounded 3-pin outlet; do not use adapters or extension cords.
• A separate circuit is recommended for this appliance.
• Never clean with flammable fluids. Do not store or use gasoline or other flammable vapors and liquids nearby.
• Do not connect or disconnect the plug with wet hands.
• Unplug the appliance before cleaning, maintenance, or servicing to prevent electrical shock or death.
• Do not attempt repairs unless specifically recommended. Refer other servicing to a qualified technician.
• Ensure sufficient people to move and install the appliance to prevent damage or injury.
• Ensure proper ventilation; the front of the unit must be unobstructed. Locate away from direct sunlight and heat sources.
• The fuse or circuit breaker should be 10 amps or higher.
• Level the appliance for proper operation by adjusting the feet.
• This appliance is not intended for use by young children. Never allow children to operate, play with, or crawl inside.
• Do not use solvent-based cleaning agents or abrasives on the interior.
• Do not use the appliance for purposes other than intended.
• Attachments not recommended by the manufacturer may be hazardous.
• When disposing of the appliance, remove the door and leave shelves in place to prevent children from climbing inside. Ensure the coolant circuit is not damaged. The ♻ symbol indicates proper disposal at a recycling collection point for electrical and electronic goods.

Structure and Installation Drawing

The following diagrams illustrate the appliance structure and installation details. Dimensions and shelf quantities may vary between models.

BUILT-UNDER SERIES (Built under a kitchen table top)

Diagram Description: A front view of the wine cooler showing the touch-key control panel with a digital display, deep shelves, shallow shelves, and the front lower section. A side view shows the cabinet, door, handle, gasket, and leveling foot.

YC-150B Installation Drawing (mm/inch)

Diagram Description: An isometric view of the YC-150B wine cooler with dimensions indicated for width, depth, and height. Key dimensions include overall width (575mm/22.6inch), depth (595mm/23.4inch), height (875mm/34.4inch), and internal dimensions. It also shows the leg height adjustment (15-30mm/0.5-1.1inch) and the lower vent area.

YC-100B Installation Drawing (mm/inch)

Diagram Description: An isometric view of the YC-100B wine cooler with dimensions indicated for width, depth, and height. Key dimensions include overall width (585mm/23inch), depth (530mm/20.8inch), height (855mm/33.6inch), and internal dimensions. It also shows the leg height adjustment (15-30mm/0.5-1.1inch) and the lower vent area.

Accessory Installation Before Operating

UNPACKING AND CLEANING THE WINE COOLER

• Remove all exterior and interior packing materials.
• Allow the appliance to stand upright for approximately 24 hours before connecting to power to reduce the possibility of cooling-system malfunction.
• Clean the interior surface with a soft cloth and lukewarm water.
• Install the door handle:
  1. Remove the gasket from the inner side of the door to expose the two screw holes.
  2. Install the handle tightly using the provided screws and washers.
  3. Replace the gasket.

Operating the Wine Cooler

POWER ON/OFF

• The appliance powers on automatically when plugged in.
• Touch the power symbol [power] to turn the appliance on or off.

Warning: To avoid compressor damage, do not turn the appliance on again within 5 minutes after turning it off.

INTERIOR LIGHTING ON/OFF CONTROL

• Touch the lighting symbol [light] to turn the interior LED lighting on or off.
• The light automatically turns off after 10 minutes for energy saving.
• To keep the light on continuously, press the lighting symbol [light] until you hear two "beeps".

SET TEMPERATURE (Upper zone and Lower zone)

• Touch the zone selection button [zone] to select the lower or upper zone. The numbers in the display window will flash.
• Use the '+' or '-' buttons to increase or decrease the temperature of the selected zone by 1°F or 1°C.

Tips:

• For mostly red wines, set the temperature between 15°C-18°C (59°F-64.4°F).
• For mostly white wines, set the temperature between 9°C-14°C (48.2°F-57.2°F).
• For mostly sparkling wines, set the temperature between 5°C-8°C (41°F-46.4°F).

Note: The temperature inside the unit is displayed in blue.

Notice: For first-time use or after a long shutdown, temperature variations are normal. The appliance will stabilize after a few hours of operation.

TEMPERATURE DISPLAY WINDOW

The digital display shows the set temperature while adjusting and the actual cabinet temperature after 5 seconds.

Warning: If the temperature probe is faulty, the display will show "HH" or "LL" with a continuous buzz. To prevent wine damage, seek immediate repair.

SELECTING FAHRENHEIT (°F) & CELSIUS (°C)

Touch the [°F/°C] button to switch between Fahrenheit and Celsius displays.

Care and Maintenance

CLEANING THE WINE COOLER

• Turn off power, unplug the appliance, and remove all items, including shelves.
• Wipe interior surfaces with a sponge and a solution of 2 tablespoons of baking soda per quart (1 litre) of warm water.
• Wash shelves with a mild detergent solution. Allow wooden shelves to dry completely before returning them to the cooler.
• Wring out excess water from the sponge or cloth when cleaning around controls or electrical parts.
• Wipe the exterior cabinet with warm water and mild liquid detergent, then dry with a clean soft cloth.
• Do not use steel wool or steel brushes on stainless steel surfaces, as this can cause contamination and rusting.

POWER FAILURE

Most power failures are short-term. Minimize door openings to maintain temperature. For extended outages, take steps to protect contents.

MOVING THE WINE COOLER

• Remove all items.
• Securely tape down loose items (shelves) inside.
• Turn adjustable legs up towards the base to prevent damage.
• Tape the door shut.
• Ensure the appliance remains upright during transportation. Protect the exterior with a blanket or similar item.

ENERGY SAVING TIPS

• Locate the appliance away from heat-producing appliances and direct sunlight.
• Ensure adequate ventilation; never cover air vents.
• Open the door only when necessary. Avoid prolonged or frequent opening/closing.

Technical Specification

Troubleshooting

Follow these steps to resolve common issues before contacting service.

Warranty

Thank you for choosing AOBOSI. The manufacturer's warranty covers the product for 12 months from the date of purchase against manufacturing faults. Warranties are automatically tracked; no registration is needed.

For assistance or questions, contact AOBOSI via website www.iaobosi.com, email info@iaobosi.com, or call +8618680277793. Provide a warranty card, photo, or video of any issues for prompt service.

AOBOSI Warranty Card

Please fill in the following details and email within 10 days of purchase:

• Item name:
• Model:
• Serial No.:
• Store name:
• Purchase date:
• Buyer's name:
• Email:
• Address:
• Tel.: