AOBOSI Compressor Wine Cooler Instruction Manual

Important Safety Instructions

⚠️ WARNING: To reduce the risk of fire, electrical shock, or injury when using your appliance, follow these basic precautions:

• Read all instructions before using the Wine cellar.
• DANGER or WARNING: Risk of child entrapment. Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are still dangerous even if they will “just sit in the garage a few days”.
• Before you throw away your old Wine Cellar: Take off the door. Leave the shelves in place so that children may not easily climb inside.
• Never allow children to operate, play with, or crawl inside the appliance.
• Never clean appliance parts with flammable fluids. The fumes can create a fire hazard or explosion.
• Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other appliance. The fumes can create a fire hazard or explosion. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
• WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction;
• WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other than those Recommended by the manufacturer;
• To avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions.
• WARNING: Do not damage the refrigerant circuit;
• WARNING: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are the type recommended by the manufacturer.
• If the refrigerant of these appliances are R600a, Flammable and explosive articles should not be put in or near the cabinet, to avoid the fire or explode caused.

Save these instructions.

Installation Instructions

Unpacking and Install the Door Handle

Remove the exterior and interior packing materials.

Install the door handle provided with the appliance by following these steps:

1. Remove the gasket at the inner side of the door to expose the two screw holes.
2. Install the handle tightly with the screws and washers provided.
3. Tidy and restore the gasket.

Diagram illustrating door handle installation components: Gasket, Flat Washer, Locker Washer, Screw, Handle, Door Frame.

Before Using Your Wine Cellar

• Remove the exterior and interior packing.
• Before connecting the Wine cellar to the power source, let it stand upright for approximately 24 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
• Use a soft cloth to clean the interior surface with lukewarm water.
• This appliance is intended to be used in household and similar applications such as: Staff kitchen areas in shops, offices and other working environments; Farm houses and by clients in hotels, motels and other residential type environments; Bed and breakfast type environments; Catering and similar non-retail applications.
• When disposing your appliance, please choose an authorized disposal site.

Installation of Your Wine Cellar

• This appliance is designed to be for free standing installation or built-in (fully recessed) (Refer to sticker location the back of this appliance).
• This appliance is intended to be used exclusively for the storage of wine or beverages.
• Place your Wine cellar on a flat floor that is strong enough to support it when it is fully loaded. To level your Wine cellar, adjust the front leveling leg at the bottom of the Wine cellar.
• This appliance is using flammability refrigerant. So never damage the cooling pipework during the transportation. Locate the Wine cellar away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.
• Avoid locating the unit in moist areas.
• Plug the Wine cellar into an exclusive, properly installed-grounded wall outlet. Do not cut or remove the third (ground) prong from the power cord under any circumstances. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Products service center.

Attention

• Store wine in sealed bottles;
• Do not overload the cabinet;
• Do not open the door unless necessary;
• Do not cover shelves with aluminum foil or any other shelf material which may prevent air circulation;
• Should the Wine cellar be stored without use for long periods, it is suggested to leave the door ajar to allow air to circulate inside the cabinet after a careful cleaning, avoiding possible formations of condensation, mold or odors.

Ambient Room Temperature Limits

This appliance is designed to operate in ambient temperatures specified by its temperature class marked on the rating plate.

Description of product model

The standard bottles as below: The stated capacity is dependent on the size and shape of standard Bordeaux 750ml bottle with diameter of 2.75". When accommodating larger bottles, you can remove shelves. This will reduce the stated bottle capacity.

Storage of Model CWC-150B

Diagram illustrating the storage capacity for the CWC-150B model. It shows shelves holding 8 bottles each (Shelves One to Five) and the bottom section holding 6 bottles. Dimensions provided: 520 mm (20.47 inch) width, 431 mm (16.97 inch) height.

Storage of Model CWC-150C

Diagram illustrating the storage capacity for the CWC-150C model. The Beverage Cooler Zone shows shelves holding 13 cans each (Shelves One to Two) and the bottom section holding 18 cans. Dimensions provided: 450 mm (17.72 inch) height, 200 mm (7.87 inch) depth. The Wine Cooler Zone shows shelves holding 3 bottles each (Shelves One to Five) and the bottom section holding 5 bottles. Dimensions provided: 443 mm (17.44 inch) height, 205 mm (8.07 inch) depth.

Storage of Model CWC-180C

Diagram illustrating the storage capacity for the CWC-180C model. The Beverage Cooler Zone shows shelves holding 24 cans each (Shelves One to Two) and the bottom section holding 32 cans. Dimensions provided: 450 mm (17.72 inch) height, 287 mm (11.3 inch) depth. The Wine Cooler Zone shows shelves holding 5 bottles each (Shelves One to Five) and the bottom section holding 6 bottles. Dimensions provided: 443 mm (17.44 inch) height, 287.5 mm (11.3 inch) depth.

Operating Your Wine Cellar and Setting the Temperature Control

FOR CWC-150B WINE COOLER

Control System Instruction:

• Power switch: Plug in, press [power button] for 3 seconds to turn on or off the unit.
• Left combination button: Press [plus button] and [minus button] at the same time for 3 seconds to change the temperature display between Celsius and Fahrenheit.
• Left display window shows the temperature of the lower zone. Pressing the left [plus button] increases temperature by 1°F or 1°C; pressing the left [minus button] decreases it by 1°F or 1°C.
• Right display window shows the temperature of the upper zone. Pressing the right [plus button] increases temperature by 1°F or 1°C; pressing the right [minus button] decreases it by 1°F or 1°C.
• Right combination button: Press [plus button] and [minus button] at the same time for 3 seconds to unlock the control panel except Light function. The control panel will automatically lock after 150 seconds from the start of no settings.
• Light button: Press [light button] to turn on or off.

FOR CWC-150C/CWC-180C WINE & BEVERAGE COOLER

Control System Instruction:

• Power switch: Plug in, press [power button] for 3 seconds to turn on or off the unit.
• Temperature setting: The temperature will increase 1°F or 1°C if you touch the [plus button] once; on the contrary, the temperature will decrease 1°F or 1°C if you touch the [minus button] once.
• Light button: Press the [light button] once to turn the light on or off, press the [°C/°F button] for 3 seconds to change the temperature display between Celsius and Fahrenheit.

Setting The Temperature Controls

When the temperature setting button is pressed, the system will enter set up mode automatically. The LED display will flash and show the setting temperature. After 5 seconds, the flash will stop and it will show the actual measured interior temperature.

Attention: If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the Wine Cellar will not start. If first time use or longer absence of using, the temperature will be different between setting and LED display temperature. After running a period, the temperature will be reverting back.

Built-Under Series

Diagram of a wine cooler installed under a kitchen counter, showing components like Touch-key Control panel & Digital Display, Deep Shelf, Front Lower, Outside Cabinet, Door, Handle, Gasket, and Leveling Foot.

Installation specifications for built-in purposes

CWC-150B

Diagram showing installation cut-out dimensions for the CWC-150B model for built-in purposes. Approximate dimensions: Height >840mm (33 in), Width >570mm (22.4 in), Depth >600mm (23 in). The unit itself measures 595mm (23.4 in) width, 840mm (33 in) height, and 570mm (22.4 in) depth.

CWC-150C

Diagram showing installation cut-out dimensions for the CWC-150C model for built-in purposes. Approximate dimensions: Height >872mm (34.3 in), Width >585mm (23 in), Depth >600mm (23.6 in). The unit itself measures 595mm (23.4 in) width, 862mm (33.9 in) height, and 575mm (22.6 in) depth.

CWC-180C

Diagram showing installation cut-out dimensions for the CWC-180C model for built-in purposes. Approximate dimensions: Height >875mm (34.4 in), Width >580mm (22.8 in), Depth >765mm (30.1 in). The unit itself measures 757mm (29.8 in) width, 865mm (34 in) height, and 570mm (22.4 in) depth.

Lock & Unlock The Door (For Option)

Lock is an optional function. If your Wine Cellar has such function, a key should be attached inside the packing of this Manual. Insert the key into the lock and turn it counter-clockwise to unlock the door. To lock it, please follow the reversed operation. Please save the key well.

CHARCOAL FILTRATION SYSTEM

Your wine is a living object that breathes through the cork of its bottle. In order to preserve the quality and taste of your fine wines, they must be stored at the ideal temperature and ambient conditions. Your cellar is equipped with an active charcoal filtration system to ensure air purity, cooling efficiency, and to maintain an odor free cabinet for the storage of your fine wines. The filter assembly is located at the rear panel inside your cellar.

Keep in mind, that this filter must be changed every 12 months and purchase the new one from the distributor.

To replace your filter:

1. Remove the bottles of wine stored on the two (2) shelves in front of the filter.
2. Remove the shelves and set aside to be replaced once you have changed the filter.
3. Hold the filter and turn it at 45 degrees in the counter-clockwise direction and then pull it out.
4. Remove the existing filter and replace with a new one.
5. Put the new filter into the hole and then turn the filter at 45 degrees in clockwise direction.

Diagram illustrating filter removal: [turn left to remove filter].

Care & Maintenance

Clean your Wine Cellar

Turn off the power, unplug the appliance, and remove all items including shelves and rack. Wash the inside surfaces with a warm water and mild solution. Wash the shelves with a mild detergent solution. Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts. Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth.

Power failure

Most power failures are corrected within a few hours and should not affect the temperature of your appliance if you minimize the number of times the door is opened. If the power is going to be off for a long period of time, you need to take the proper steps to protect your contents.

Vacation Time

Short vacations: Leave the Wine Cellar operating during vacations of less than three weeks.

If the appliance will not be used for several months, remove all items and turn off the appliance. Clean and dry the interior thoroughly. To prevent odor and mold growth, leave the door open slightly: blocking it open if necessary.

Moving your Wine Cellar

Remove all items. Take out the loose items inside the wine cellar (such as shelf), or fix the loose items with the foam. Turn the adjustable leg up to the base to avoid damage. Tape the door shut. Be sure the appliance stays secure in the upright position during transportation. Also protect outside of appliance with a blanket or similar items.

Energy saving tips

The Wine Cellar should be located in the coolest area of the room, away from producing appliances, and out of the direct sunlight.

Troubleshooting Guide

If you feel the appliance is out of order, follow these instructions to try to see if you can solve the problem simply by yourself before calling for service.

Technical Specification

Manufacturer: Foshan Shunde QINGZHOU Electric Appliances Co., Ltd.

Address: ROOM 2901, BUILDING 18, VANKE JINYU RIVERSIDE PLAZA, NO.13 DESHENG MIDDLE ROAD, DALIANG STREET, SHUNDE DISTRICT, FOSHAN CITY, GUANGDONG PROVINCE

Contact: Kelly, Tel: +1(838)900 9806, E-Mail: info@iaobosi.com