ClearClick® Present+Share (USB-C Edition)

Warranty & Support

2-Year Warranty & USA-Based Tech Support

For technical support, email: support@clearclick.com

Extend your warranty to 3 years for free by registering at: www.ClearClick.com/Register/

Visit ClearClick: www.ClearClick.com

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

SAR Statement (TX): This device complies with FCC SAR requirements. The highest reported 1g-SAR for body is 0.287 W / Kg.

For body-worn operation, this device has been tested and meets the FCC RF exposure guidelines for use with an accessory that contains no metal and positions the device a minimum of 0mm from the body. RF exposure compliance with any body-worn accessory that contains metal was not tested and certified. Use of such body-worn accessory should be avoided. Accessory available in market and must be used to keep use distance 0mm from EUT to body-worn operation.

RF Exposure Statement (RX): To maintain compliance with FCC's RF Exposure guidelines, this equipment should be installed and operated with minimum distance of 20cm from the radiator to your body. This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.

Additional Information

Additional Transmitters Available: This system supports up to 8 transmitters. To purchase additional transmitters, please visit: www.ClearClick.com

Extend Your Warranty for FREE! Extend your warranty by one year for free simply by registering your product at: www.ClearClick.com

Safety Precautions

Important, Please Read:

1. Do not disassemble the units.
2. Do not permit children to use or play with this device.
3. Please note that the devices may become very warm during use.
4. Do not operate the unit around water or rain. Do not operate the unit around any unnecessary machines or appliances.
5. Unplug the units when not in use.
6. Use only the included accessories with the device.

2-Year Warranty

Your purchase comes with a 2-year warranty. This means that if anything goes wrong with the unit (other than accidental damage) within the first 2 years of ownership, ClearClick will replace the unit for free, 100% at their cost. Contact support at support@clearclick.com with any issues.

What's In The Box?

The ClearClick Present+Share system includes:

• 2 USB-C Transmitters (TX)
• 1 HDMI Receiver (RX)
• 1 USB-C Power Cable (For RX/Receiver)

Description of visual: The image shows two black rectangular transmitter units labeled 'TX' and one black rectangular receiver unit labeled 'RX', each connected to a short cable with a USB-C connector. The receiver also has an HDMI connector visible.

Recommended System Requirements

A PC/Mac/Phone/Netbook/Tablet with a USB-C port that supports USB-C video output (DisplayPort Alt Mode).

Recommended minimum model year: 2018.

Phones/Tablets must have a USB-C port. (Lightning port & micro USB are not supported.)

Quick Start Guide

1. Plug in the receiver (RX) to your TV, monitor, or projector via HDMI.
2. Connect the USB-C port of the receiver (RX) to a USB port or power supply for power (required).
3. Connect a transmitter (TX) to your PC/Mac/Netbook/Phone/Tablet's USB-C port. (Refer to System Requirements on the previous page.)
4. Press the button on the transmitter (TX) to start transmitting to the receiver (RX) attached to your TV, monitor, or projector.
5. Within a few seconds, your TV/monitor/projector will show the video signal that it is receiving from your device.
6. Important Note - How to Use the Second Transmitter (TX): If the first transmitter (TX) is transmitting/in use, you must first "unlink" it by pressing the button on the first transmitter (TX) again (or unplugging it entirely). This will "unlink" the first transmitter and allow you to transmit from the second transmitter (TX).

Technical Specifications

For product support or to purchase additional transmitters (TX), please visit: www.ClearClick.com

Email: support@clearclick.com

© 2023 ClearClick Software LLC. All rights reserved.